Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 239

28. Install a new right-hand tie rod-end retaining nut.

Tighten to 35 Nm.

29. Loosely install a new wheel right-hand hub nut.

30. Remove the engine rear lifting eye.

31. Install the engine cover rear mount bracket.

Tighten to 23 Nm.

32. Attach the electrical connector.

33. Attach the engine harness.

34. Raise the engine, suspension and transmission assembly to a suitable

height.

35. NOTE: Remove the tie straps.

Reposition the air conditioning (A/C) pipe to the engine, suspension and
transmission assembly.

36.

W ARNING: Raise the special tool platform slowly. Failure to

follow this instruction can result in personal injury.

Install the engine.

Raise the special tool.

37. NOTE: Left-hand shown, right-hand similar.

Make sure the special tool rear height adjuster aligns into the locating
hole in the vehicle floor pan.

38. NOTE: Left-hand shown, right-hand similar.

Loosely install the front subframe retaining bolts.

39. NOTE: Left-hand shown, right-hand similar.

Install the front subframe reinforcement plate.

Loosely install the front subframe rear retaining bolts.

40. NOTE: Left-hand shown, right-hand similar.

Install the front subframe reinforcement plate retaining bolts.

Tighten to 70 Nm.

41. NOTE: Left-hand shown, right-hand similar.

Fully tighten the front subframe retaining bolts.

Tighten to 142 Nm.

42. NOTE: Left-hand shown, right-hand similar.

Fully tighten the front subframe retaining bolts.

Tighten to 142 Nm.

43. NOTE: Install new retaining nuts.

Install the engine front mount retaining nuts.

Tighten to 80 Nm.

44. NOTE: Install a new retaining nut.

Install the engine rear mount retaining nut.

Tighten to 133 Nm.

45. Remove the special tool.

46. Lower the vehicle.

47. Attach the strut and spring assembly.

Tighten to 30 Nm.

48. NOTE: Remove the tie straps.

Attach the selector cables.