Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 240
49. Attach the selector cables.
50. Attach the engine wiring harness earth lead.
Tighten to 10 Nm.
51. Attach the engine wiring harness retaining clip.
52.
CAUTION: Make sure that the electrical connector locates
correctly in the ECM. Do not force or overtighten the electrical connector.
Failure to follow this instruction may result in damage to the components.
• NOTE: Bolt remains captive in the ECM electrical connector.
Using the special tool, connect the ECM harness electrical connector.
Tighten to 10 Nm.
53. Attach the engine wiring harness electrical connector.
54. Install the engine wiring harness trim panel.
55. Attach the engine wiring harness retaining clip.
56. Connect the fuel lines.
For additional information, refer to:
Quick Release Coupling - Push
Connect
(310-00 Fuel System - General Information, General
Procedures).
Remove the blanking plugs.
57. NOTE: Install new O-ring seals.
• NOTE: Un-cap the exposed ports.
Connect the air conditioning (A/C) compressor lines.
58. Fully tighten the A/C compressor line retaining bolt.
Tighten to 20 Nm.
59. Connect the power assisted steering hose.
60. Connect the charge air cooler hose.
Tighten to 4 Nm.
61. Connect the radiator upper coolant hose.
62.
CAUTION: If brake fluid is spilt on the paintwork, the affected
area must be immediately washed down with cold water.
• NOTE: Un-cap the exposed ports.
• NOTE: Remove the tie strap.
Attach the clutch slave cylinder pipe.
Connect and fully seat the clutch slave cylinder pipe and retaining
clip.
63. Attach the wiring harness to the battery tray mount.
64. Connect the battery cables.
65. Connect the glow plug harness electrical connector.
66. Connect the engine harness electrical connector.
Tighten to 10 Nm.
67. Attach the the expansion tank outlet hose.
68. Connect the expansion tank outlet hose.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст