Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 71
Published: 11-May-2011
Rear Disc Brake -
Lubricants, Fluids, sealers and Adhesives
CAUTION: Do not use brake fluid ITT Super Dot 4 on 2006my vehicles onwards. Failure to follow this instruction may result in damage
to the vehicle.
• NOTE: Brake fluid ITT Super Dot 4 has now been superseded by Shell ESL Super Dot 4 which is the Jaguar recommended brake fluid. Shell
ESL Super Dot 4 can be used on all model years.
Item
Specification
Brake fluid
ITT Super Dot 4
Brake fluid
Shell ESL Super Dot 4
Caliper slide pin grease
Dow Corning G807
Torque Specifications
Description
Nm
lb-ft
lb-in
Brake hose union
38
28
-
Brake caliper anchor plate retaining bolt
70
52
-
Brake caliper retaining bolt
32
24
-
Published: 11-May-2011
Rear Disc Brake - Rear Disc Brake
Description and Operation
Item
Part Number
Description
1
—
Parking brake cable
2
—
Hub carrier
3
—
Brake hose
4
—
Brake disc shield
5
—
Brake caliper
6
—
Brake caliper anchor plate
7
—
Brake pads
8
—
W heel hub
9
—
Brake disc
WARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with the eyes. W ash hands thoroughly after handling.
If brake fluid contacts the eyes, flush the eyes for 15 minutes with cold running water. Get medical attention if irritation persists. If taken
internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal
injury.
• NOTE: Brake system materials inherently generate heat in order to dissipate energy. As a result, occasional squeal is possible, which may
be compounded by severe environmental conditions, such as cold, heat, rain, snow, salt and mud.
The rear disc brake system consists of the following components:
Brake pads.
Single piston, floating disc calipers.
Brake discs.
Brake caliper anchor plates.
Brake hoses.
Parking brake cables.
The caliper has two retaining bolts that attach the caliper to the anchor plate. The anchor plate is attached to the hub carrier with two
bolts. The hydraulic system provides separate circuits for each pair of diagonally opposed wheels (i.e.left front, right rear and right front,
left rear).
The brake disc is manufactured from cast iron and is of the solid type. It is retained on the hub by the wheel and the wheel studs.
The rear brake calipers are mounted on the hub carrier. These are of single, sliding piston type which ensures that equal effort is applied
through both brake pads.
The rear brake caliper incorporates the parking brake which is self adjusting according to brake pad wear.
Published: 11-May-2011
Rear Disc Brake - Rear Disc Brake
Diagnosis and Testing
For additional information, refer toSection
206-00 Brake System - General Information
.
Published: 11-May-2011
Rear Disc Brake - Brake Caliper
Removal and Installation
Special Tool(s)
Brake pedal hold-down tool
JDS 9013
Brake caliper piston retractor tool
206-080
Crankshaft pulley/damper remover
303-588
Removal
1. Remove the wheel and tire.
For additional information, refer to:
Wheel and Tire
(204-04 Wheels and
Tires, Removal and Installation).
2. Detach the parking brake cable.
1. Release the tension.
2. Detach the parking brake cable.
3. Remove the parking brake cable retaining clip.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст