Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 519
Published: 11-May-2011
Parking Aid - Parking Aid ModuleWagon
Removal and Installation
Removal
1. Raise the loadspace floor covering.
2. Remove the loadspace floor covering.
3. Remove the centre loadspace stowage compartment.
4. Disconnect the electrical connector.
5. Disconnect the electrical connector.
6. Disconnect the electrical connector.
7. Remove the parking aid module.
Installation
1. To install, reverse the removal procedure.
Published: 11-May-2011
Parking Aid - Rear Parking Aid Sensor
Removal and Installation
Removal
1. Detach the bumper lower black out panel.
2. Disconnect the electrical connector.
3.
CAUTION: Make sure excessive pressure or tools are not used
when removing the sensor from the sensor housing.
Remove the sensor.
Unclip the sensor from the sensor housing.
Installation
1. To install, reverse the removal procedure.
Published: 11-May-2011
Parking Aid - Rear Parking Aid Speaker4-Door
Removal and Installation
Removal
1. Remove the rear parcel shelf. For additional information, refer to
Section
501-05 Interior Trim and Ornamentation
.
2. Disconnect the electrical connector.
3. Remove the speaker.
Remove and discard the rivets.
Installation
1. NOTE: Install new rivets.
To install, reverse the removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст