Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 178

73. Install the water pump and coolant hose assembly.

1. Attach the hose.

2. Install the water pump and coolant hose assembly.

Tighten to 25 Nm.

74. NOTE: Install new coolant crossover O-ring seals.

Install the coolant crossover tube.

Tighten to 10 Nm,

75. Install the engine oil pressure and oil temperature sensors.

Tighten to 14Nm.

76. NOTE: Install new O-ring seals.

Install the oil filter housing assembly.

Tighten all oil filter housing retaining bolts to 25 Nm.

77. Tighten the oil filter housing assembly retaining bolts in sequence.

1. Tighten to 150 Nm.

2. Tighten to 40 Nm + 90 degrees.

78. Install the engine rear backing plate.

79. Install the flywheel.

Prevent the engine from rotating.

Tighten to 80 Nm.

80. NOTE: Right-hand shown, Left-hand similar.

Install the exhaust manifolds.

Tighten to 25 Nm.

81. NOTE: Right-hand shown, Left-hand similar.

Install the exhaust manifold heat shields.

Tighten to 10 Nm.

82. NOTE: Install a new O-ring seal.

Install the oil level indicator tube.

83. Install the A/C compressor mounting bracket.

Tighten to 25 Nm.

84. Install the air conditioning (A/C) compressor.

Tighten to 25 Nm.

85. Install the power steering pump.

Tighten to 25 Nm.

86. Install the generator.

Tighten to 48 Nm.

87. Install the right-hand idler pulley.

Tighten to 25 Nm.

88. Install the accessory drive belt.

1. Use a 3/8 inch drive bar to release the accessory drive belt

tensioner.

2. Install the accessory drive belt.

89. Install the left-hand knock sensor.

Tighten to 25 Nm.

90. Install new lower intake manifold gaskets.

91. Install the lower intake manifold and injector supply manifold.

Tighten to 10 Nm.

92. Install the ignition coils.

Tighten to 10 Nm.