Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 401
• NOTE: Shift cable has a black cover to cable end and the selector cable has a white cover to cable end.
6. Detach the red locking tab on the shift cable.
7. Attach the shift cable to the ball pin on the transmission selector.
8. Press the red locking tab to secure the position of the shift cable.
9. Place the transmission selector into the neutral position.
10. Detach the red locking tab on the selector cable.
11. Attach the selector cable to the ball pin on the gearbox mass damper.
12. Press the red locking tab to secure the position of the selector cable.
13. Remove the gearshift selector setting tool.
14. Install the gearshift lever surround.
15. Check for correct operation of gear controls.
16. Install the wheel and tire. For additional information, refer to Section
204-04 W heels and Tires
Published: 11-May-2011
Manual Transmission/Transaxle and Clutch - General Information - Release Hub and
Bearing Check
General Procedures
1. Turn the clutch release hub and bearing in both directions and check for
any binding or abnormal noise.
2.
CAUTION: The clutch release hub and bearing is sealed and must
not be immersed in any type of cleaning fluid.
Check for worn or damaged clutch release hub and bearing contact
surfaces.
3. Install the clutch release hub and bearing on the input shaft and check
for a smooth sliding condition.
Published: 11-May-2011
Clutch -
Torque Specifications
Description
Nm
lb-ft
lb-in
Pressure plate retaining bolts
25
18
-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст