Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 503
Published: 11-May-2011
Air Conditioning - Air Conditioning
Diagnosis and Testing
For additional information refer toSection
412-00 Climate Control System - General Information
.
Published: 11-May-2011
Air Conditioning - Air Conditioning (A/C) Compressor2.0L NA V6 - AJV6/2.5L NA V6 -
AJV6/3.0L NA V6 - AJ27
Removal and Installation
Removal
1. Reclaim the refrigerant. For additional information, refer toSection
412-00 Climate Control System - General Information
.
2. Raise and support the vehicle. For additional information, refer to
Section
100-02 Jacking and Lifting
.
3. Detach the accessory drivebelt.
1. Using the special tool, rotate the belt tensioner counter
clockwise.
2. Detach the accessory drivebelt
4. Disconnect the electrical connector.
5. NOTE: Seal the tube and the compressor with plugs
Detach the compressor supply and return tubes.
6. Remove and discard the compressor O-rings.
7. Remove the compressor.
Installation
1. NOTE: Install new O-ring seals.
• NOTE: Coat the refrigerant line O-ring seals in clean refrigerant oil prior
to installation.
• NOTE: 5oz of oil are contained in the new compressor. The air
conditioning system requires a total of 7oz of oil.
To install, reverse the removal procedure.
Tighten to 25 Nm.
2. Tighten to 25 Nm.
Published: 11-May-2011
Air Conditioning - Air Conditioning (A/C) Compressor2.0L Duratorq-TDCi/2.2L
Duratorq-TDCi (110kW/150PS) - Puma
Removal and Installation
Special Tool(s)
Release tool, belt tensioner
303-676
Removal
1. Recover the air conditioning (A/C) refrigerant.
For additional information, refer to:
Air Conditioning (A/C) System
Recovery, Evacuation and Charging
(412-00 Climate Control System -
General Information, General Procedures).
2. Remove the air cleaner.
For additional information, refer to:
Air Cleaner
(303-12B Intake Air
Distribution and Filtering - 2.0L Duratorq-TDCi/2.2L Duratorq-TDCi
(110kW/150PS) - Puma, Removal and Installation).
3. Loosen the A/C compressor supply and return tubes retaining bolt.
4. Disconnect the electrical connector.
5. Detach the engine wiring harness from the retaining bracket.
6. Remove the air deflector.
For additional information, refer to:
Air Deflector - 2.0L Duratorq-
TDCi/2.2L Duratorq-TDCi (110kW /150PS) - Puma
(501-02 Front End Body
Panels, Removal and Installation).
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст