Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 73
Published: 11-May-2011
Rear Disc Brake - Brake Pads
Removal and Installation
Special Tool(s)
Brake caliper piston retractor tool
206-080
Crankshaft pulley/damper remover
303-588
Removal
1. Remove the wheel and tire.
For additional information, refer to:
Wheel and Tire
(204-04 Wheels and
Tires, Removal and Installation).
2. Detach the parking brake cable.
1. Release the tension.
2. Detach the parking brake cable.
3. Remove the parking brake cable retaining clip.
4. Detach the brake caliper and secure to one side.
Remove and discard the brake caliper retaining bolts.
5. Remove the brake pads.
Installation
1.
CAUTION: If the piston is pushed back into the housing, brake
fluid will be forced back into the fluid reservoir.
• NOTE: The left-hand brake caliper piston retracts counter clockwise and
the right-hand retracts clockwise.
Using the special tools, fully retract the brake caliper piston.
2. Install the brake pads.
3. CAUTIONS:
Make sure that the brake disc faces are clean before installation.
Make sure the piston location mark is in the correct position so that
the locator pin on the brake pad backing plate locates correctly into the
piston.
• NOTE: Install new brake caliper retaining bolts.
Attach the brake caliper.
Tighten to 32 Nm.
4. Attach the parking brake cable retaining clip.
5. Attach the parking brake cable.
1. Release the tension.
2. Attach the parking brake cable.
6. Install the wheel and tire.
For additional information, refer to:
Wheel and Tire
(204-04 Wheels and
Tires, Removal and Installation).
Published: 11-May-2011
Parking Brake and Actuation -
Torque Specifications
Description
Nm
lb-ft
lb-in
Parking brake control retaining nuts
20
15
-
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст