Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 264
7. NOTE: Fuel may still be present in the fuel injection supply manifold.
Detach the fuel injection supply manifold and lower intake manifold and
place to one side.
Remove and discard the lower intake manifold O-ring seals.
8. Remove the fuel injection supply manifold and lower intake manifold.
Disconnect the electrical connector.
9. Remove the lower intake manifolds.
Remove and discard the fuel injector O-ring seals.
10. Remove the fuel charging wiring harness.
Disconnect the electrical connectors.
Vehicles with 2.0L engine
11. Remove the fuel rail.
For additional information, refer to
Fuel Injection Supply Manifold
in this
section.
12. Disconnect the electrical connector.
13. Remove the fuel charging wiring harness.
Installation
Vehicles with 2.0L engine
1. To install, reverse the removal procedure.
Vehicles with 2.5L or 3.0L engine
2. NOTE: Install new fuel injector O-ring seals.
• NOTE: Install new lower intake manifold O-ring seals.
To install, reverse the removal procedure.
Tighten to 10 Nm.
3. Tighten in the sequence shown.
Tighten to 10 Nm.
Published: 11-May-2011
Fuel Charging and Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27
- Fuel Injection Supply Manifold
Removal and Installation
Removal
All vehicles
1. Disconnect the battery ground cable.
For additional information, refer to Section
414-01 Battery, Mounting
and Cables
.
2. Disconnect the spring lock coupling.
For additional information, refer to Section
310-00 Fuel System -
General Information
.
Vehicles with 2.5L or 3.0L engine
3. Remove the fuel injectors. For additional information, refer to
Fuel
Injectors
.
Vehicles with 2.0L engine
4. Disconnect the electrical connector.
Detach the harness.
5. Remove the engine trim retaining bracket.
6. Remove the injector retaining clip.
7. Remove the fuel rail retaining bolts.
8. Disconnect the fuel rail from the injectors.
9. Remove the fuel injection rail.
1. Rotate the fuel injection rail through 180°.
2. Remove the fuel injection rail.
Vehicles with 2.5L or 3.0L engine
10. Remove the fuel pressure sensor.
Remove and discard the gasket.
Installation
All vehicles
1. NOTE: Install new fuel injector O-ring seals.
To install, reverse the removal procedure.
Lubricate the fuel injector O-ring seals with clean engine oil.
Vehicles with 2.5L or 3.0L engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст