Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 265
2. NOTE: Install a new gasket.
Tighten to 10 Nm.
Vehicles with 2.0L engine
3. Tighten to 10 Nm.
4. Tighten to 6 Nm.
Published: 11-May-2011
Fuel Charging and Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27
- Fuel Injectors
Removal and Installation
Removal
Vehicles with 2.5L or 3.0L engine
1. Remove the fuel charging wiring harness.
For additional information, refer to
Fuel Charging W iring Harness
in this
section.
2. Remove the fuel injectors.
Remove the fuel injector retaining clips.
Vehicles with 2.0L engine
3. Remove the fuel injection supply manifold.
For additional information, refer to
Fuel Injection Supply Manifold
in this
section.
4. Detach the injectors from the lower intake manifold.
5. Remove the injectors.
Disconnect the electrical connectors.
All vehicles
6. Remove and discard the O-ring seals.
7.
Installation
1. NOTE: Install new fuel injector O-ring seals.
To install, reverse the removal procedure.
Lubricate the fuel injector O-ring seals with clean engine oil.
Published: 11-May-2011
Fuel Charging and Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27
- Fuel Pulse Damper2.5L NA V6 - AJV6/3.0L NA V6 - AJ27
Removal and Installation
Removal
1. Remove the throttle body. For additional information, refer to
Throttle
Body
.
2. Disconnect the electrical connector.
3. Detach the fuel pressure sensor vacuum line.
4. Remove the fuel pressure sensor.
Remove and discard the gasket.
Installation
1. NOTE: Install a new gasket.
To install, reverse the removal procedure.
Tighten to 10 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст