Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 697
19. Detach the engine roll restrictor.
20. Remove the engine roll restrictor.
Remove the roll restrictor retaining bolt.
21. NOTE: Left-hand shown, right-hand similar.
Remove the front subframe reinforcement plate retaining bolts.
22. NOTE: Left-hand shown, right-hand similar.
Remove the front subframe rear mount retaining bolts.
23. NOTE: Right-hand shown, left-hand similar.
Remove the front subframe front mount retaining bolts.
24. Detach the right-hand side of the steering gear.
25. Detach the left-hand side of the steering gear.
26. Using suitable securing straps, secure the steering gear to the vehicle
body.
27.
CAUTION: To prevent damage to the lower arm bushing, detach
the lower arm ball joint as the subframe is being lowered. Failure to follow
this instruction may result in damage to the vehicle.
• NOTE: Right-hand shown, left-hand similar.
Detach the lower arm.
28.
W ARNING: Rotate the special tool height adjustment valve
slowly. Failure to follow this instruction may result in personal injury.
Remove the subframe.
Rotate the special tool height adjustment valve counter clockwise.
Lower the special tool.
Installation
All vehicles
1.
W ARNING: Raise the special tool platform slowly. Failure to follow
this instruction can result in personal injury.
Install the subframe.
Raise the special tool platform.
2.
CAUTION: To prevent damage to the lower arm bushing, attach
the lower arm ball joint as the subframe is being raised. Failure to follow
this instruction may result in damage to the vehicle.
• NOTE: Right-hand shown, left-hand similar.
Attach the lower arm.
3. NOTE: Left-hand shown, right-hand similar.
Make sure the special tool rear height adjuster aligns into the locating
hole in the vehicle floor pan.
4. Remove the steering gear securing straps.
5. Attach the left-hand side of the steering gear.
Tighten to 133 Nm.
6. Attach the right-hand side of the steering gear.
Tighten to 133 Nm.
7. NOTE: Right-hand shown, left-hand similar.
Loosely install the front subframe front mount retaining bolt.
8. NOTE: Left-hand shown, right-hand similar.
Loosely install the front subframe rear mount retaining bolts.
9. NOTE: Left-hand shown, right-hand similar.
Loosely install the front subframe reinforcement plate retaining bolts.
10. NOTE: Right-hand shown, left-hand similar.
Tighten to 142 Nm.
11. NOTE: Left-hand shown, right-hand similar.
Tighten to 142 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст