Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 90
10. Install the speed control module retaining bolt.
Tighten to 4 Nm.
11. Connect the speed control module electrical connector.
12. Attach the throttle cable retaining bracket.
13. Attach the IAC valve wiring harness.
14. Attach the throttle cable.
1. Reposition the throttle lever to the fully open position.
2. Attach the throttle cable.
15. Attach the cruise control cable.
All vehicles
16. Attach the coolant expansion tank.
1. Reposition the coolant expansion tank.
2. Attach the coolant expansion tank.
17. Install the coolant expansion tank retaining bolt.
Tighten to 3 Nm.
18. NOTE: Remove the blanking plugs from the cooling system vent hoses
and the coolant expansion tank.
Attach the cooling system vent hoses to the coolant expansion tank.
19. Attach the brake fluid low level warning indicator wiring harness to the
coolant expansion tank.
20. Connect the brake fluid low level warning indicator electrical connector.
21. Install the brake booster push rod retaining clip.
22. Check and top up the cooling system as required.
Vehicles with manual transmission
23. Bleed the clutch system.
For additional information, refer to:
Clutch System Bleeding - Vehicles
W ith: 6-Speed Manual Transaxle - MMT6
(308-00 Manual
Transmission/Transaxle and Clutch - General Information, General
Procedures).
Published: 11-May-2011
Power Brake Actuation - Brake BoosterRHD AWD/RHD FWD
Removal and Installation
Special Tool(s)
Brake pedal hold down tool
JDS 9013
Removal
All vehicles
1. Disconnect the brake fluid low level warning indicator electrical
connector.
2. Detach the brake fluid low level warning indicator wiring harness from
the coolant expansion tank.
3. NOTE: Install blanking plugs to the cooling system vent hoses and the
coolant expansion tank.
Detach the cooling system vent hoses from the coolant expansion tank.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст