Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 91

4. Remove the coolant expansion tank retaining bolt.

5. Reposition the coolant expansion tank.

1. Detach the coolant expansion tank.

2. Reposition the coolant expansion tank.

Vehicles with 2.0L engine

6. Detach the cruise control cable.

7. Detach the throttle cable.

1. Reposition the throttle lever to the fully open position.

2. Detach the throttle cable.

8. Detach the idle air control (IAC) valve wiring harness.

9. Detach the throttle cable retaining bracket.

10. Disconnect the speed control module electrical connector.

11. Remove the speed control module retaining bolt.

12. Reposition the speed control module.

Vehicles with manual transmission

13.

CAUTION: If brake fluid is split on the paintwork, the affected

area must be immediately washed down with cold water. Failure to follow
this instruction may result in damage to the vehicle.

• NOTE: Install blanking plugs to the clutch master cylinder feed hose and
the brake fluid reservoir.

Detach the clutch master cylinder feed hose.

All vehicles

14. Detach the brake fluid supply tubes from the retaining clip.

15. Detach the brake master cylinder assembly from the brake booster.

Remove and discard the O-ring seal at the rear of the brake master
cylinder.

16. Using a suitable cord, reposition the brake master cylinder assembly.

17. Detach the brake booster vacuum hose.

18. Detach the brake booster.

Remove the brake booster retaining nuts.

19. Remove the brake booster support bracket.

20. Using the brake pedal hold down tool, apply the brake pedal until the

brake booster push rod pin can be removed.

21. Remove the brake booster push rod pin retaining clip.