Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 363
1. To install, reverse the removal procedure.
Install the new O-ring seals.
2. To install, reverse the removal procedure.
Tighten to 8 Nm.
3. Tighten to 8 Nm.
4. NOTE: Apply an even bead of silicone gasket sealant WSE-M4G323-A6
or equivalent meeting Jaguar specification to the main valve body cover
sealing surface.
Tighten to 8 Nm.
5. Check and adjust the transmission fluid level. For additional
information, refer to
Adjustment—Fluid Level Check
.
Published: 11-May-2011
Automatic Transmission/Transaxle - Vehicles With: 5-Speed Automatic Transaxle -
JATCO - Shift Solenoids (SS)
In-vehicle Repair
Removal
1. Remove the main control valve body. For additional information, refer to
Main Control Valve Body
.
2. Disconnect the electrical connector.
3. Remove the shift solenoid.
Installation
1. NOTE: Lubricate the shift solenoid O-ring seal with automatic
transmission fluid WSS-M2C922-A1 or equivalent meeting Jaguar
specification.
To install, reverse the removal procedure.
Lubricate the shift solenoid O-ring seal.
2. Tighten to 8 Nm.
3. Install the main control valve body. For additional information, refer to
Main Control Valve Body
.
Published: 11-May-2011
Automatic Transmission/Transaxle - Vehicles With: 5-Speed Automatic Transaxle -
JATCO - Transaxle Support Insulator
In-vehicle Repair
Special Tool(s)
Powertrain assembly jack
HTJ1200-2
Removal
1. Raise and support the vehicle. For additional information, refer to
Section
100-02 Jacking and Lifting
.
2. Install the special tool.
3. NOTE: Left-hand shown, right-hand similar.
Position and adjust the special tool rear height adjuster.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст