Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 362
Published: 11-May-2011
Automatic Transmission/Transaxle - Vehicles With: 5-Speed Automatic Transaxle -
JATCO - Halfshaft Seal LH
In-vehicle Repair
Special Tool(s)
Link shaft oil seal installer
205-115
Pinion oil seal remover
308-208
Removal
1. Drain the transmission. For additional information, refer to
Transmission
Fluid Drain and Refill
.
2. Remove the left-hand drive halfshaft. For additional information, refer
to Section
205-04 Front Drive Halfshafts
.
3. Using the special tool, remove the drive halfshaft oil seal.
Installation
1. Using the special tool, install the drive halfshaft oil seal.
2. Install the left-hand drive halfshaft. For additional information, refer to
Section
205-04 Front Drive Halfshafts
.
3. Fill the transmission. For additional information, refer to
Transmission
Fluid Drain and Refill
Published: 11-May-2011
Automatic Transmission/Transaxle - Vehicles With: 5-Speed Automatic Transaxle -
JATCO - Halfshaft Seal RH
In-vehicle Repair
Special Tool(s)
Linkshaft oil seal installer
205-115
Pinion oil seal remover
308-208
1. Drain the transmission.
For additional information, refer to
Transmission Fluid Drain and Refill
in
this section.
2. Remove the intermediate shaft.
For additional information, refer to Section
205-04 Front Drive
Halfshafts
.
Removal
1. NOTE: Left-hand shown, right-hand similar.
Using the special tool, remove the halfshaft oil seal.
Installation
1. Using the special tool install, the halfshaft oil seal.
2. Install the intermediate shaft.
For additional information, refer to Section
205-04 Front Drive
Halfshafts
.
3. Refill the transmission.
For additional information, refer to
Transmission Fluid Drain and Refill
in
this section.
Published: 11-May-2011
Automatic Transmission/Transaxle - Vehicles With: 5-Speed Automatic Transaxle -
JATCO - Main Control Valve Body
In-vehicle Repair
Removal
1. Detach the wiring harness.
2. Remove the main valve body cover.
Drain the transmission fluid into a suitable container.
Clean and inspect the main valve body cover and transmission
sealing surfaces using Metal surface cleaner WSE-M5B392-A or
equivalent meeting Jaguar specification.
3. Disconnect the electrical connectors.
4. Detach the wiring harness.
5. Remove the main control valve body.
6. Remove and discard the O-ring seals.
Installation
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст