Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 141

39. Attach the wiring harness.

40. Connect the electrical connectors.

41. Install the coolant hoses.

42. Attach the throttle cable bracket.

Tighten to 9 Nm.

43. Attach the throttle cable.

1. Reposition the throttle lever to the fully open position.

2. Attach the throttle cable.

44. Attach the cruise control cable.

45. Connect the throttle position sensor electrical connector.

46. Connect the idle actuator control valve electrical connector.

47. Attach the positive crank case venilation hose.

Vehicles with 2.5L or 3.0L engine

48. Attach the positive crank case ventilation hose.

All vehicles

49. Install the automatic or manual transmission. For additional

information, refer to Section

307-01A Automatic

Transmission/Transaxle

Section

307-01B Automatic

Transmission/Transaxle

or Section

308-03 Manual

Transmission/Transaxle

.

50. NOTE: Use oil WSE-M2C908-A or equivalent meeting Jaguar
specification.

Refill the engine with oil.

Published: 11-May-2011

Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Engine Front
Mount

In-vehicle Repair

Special Tool(s)

Powertrain Assembly Jack

HTJ1200-02

Removal

1. Drain the cooling system. For additional information, refer to .

For additional information, refer to:

Cooling System Draining, Filling and

Bleeding

(303-03A Engine Cooling - 2.0L NA V6 - AJV6/2.5L NA V6 -

AJV6/3.0L NA V6 - AJ27, General Procedures).

2. Install the special tool.

3. NOTE: Left-hand shown, right-hand similar.

Position and adjust the special tool rear height adjuster.