Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 140
20. NOTE: Apply a 5 mm diameter bead of silicone gasket sealant
WSE-M4G323-A6 or equivalent meeting Jaguar specification on the half
round gaskets and apply an 8 mm diameter bead of silicone gasket
sealant on the two places where the cylinder head and front timing cover
join.
• NOTE: Make sure that the valve cover isolator mounts are correctly
installed to the new valve cover gaskets.
Install the new valve cover gaskets.
Complete the tightening sequence.
Tighten to 10 Nm.
21. Install the right-hand ignition coils.
Tighten to 6 Nm.
22. Connect the right-hand ignition coils electrical connectors.
23. NOTE: Apply a 5 mm diameter bead of silicone gasket sealant
WSE-M4G323-A6 or equivalent meeting Jaguar specification on the half
round gaskets and apply an 8 mm diameter bead of silicone gasket
sealant on the two places where the cylinder head and front timing cover
join.
• NOTE: Make sure that the valve cover isolator mounts are correctly
installed to the new valve cover gaskets.
Install the new valve cover gaskets.
Complete the tightening sequence.
Tighten to 10 Nm.
24. Install the coolant hose.
Tighten to 6 Nm.
Vehicles with 2.0L engine
25. Install the heated positive crank case ventilation valve coolant hoses.
All vehicles
26. NOTE: Right-hand shown, left-hand similar.
Install the (CMP) semsors.
Tighten to 7 Nm.
27. NOTE: Right-hand shown, left hand similar.
Connect the camshaft position sensor electrical connector.
28. Connect the variable camshaft timing (VCT) solenoid electrical
connector.
29. Install the left-hand ignition coils.
Tighten to 6 Nm.
30. Connect the left-hand ignition coils electrical connectors.
31. NOTE: 2.5L and 3.0L shown, 2.0L similar.
• NOTE: The intake manifold retaining bolts numbered 1, 2 and 3 are
longer than the retaining bolts numbered 4, 5 and 6.
Install the new intake manifold gaskets.
Complete the tightening sequence.
Tighten to 10 Nm.
32. NOTE: 2.5L and 3.0L shown, 2.0L similar.
Install the intake manifold support bracket.
Tighten to 10 Nm.
33. NOTE: 2.5L and 3.0L shown, 2.0L similar.
Install the intake manifold support bracket.
Tighten to 10 Nm.
34. NOTE: 2.5L and 3.0L shown, 2.0L similar.
Tighten to 6 Nm.
Vehicles with 2.5L or 3.0L engine
35. Connect the vacuum hose.
36. Attach the wiring harness.
Tighten to 10 Nm.
37. Connect the electrical connectors.
38. Connect the electrical connectors.
Vehicles with 2.0L engine
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст