Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 182

22.

CAUTION: Never use jointing compound forward of the catalytic

converter. Failure to follow this instruction may result in damage to the
component.

• NOTE: Make sure the retaining nuts are tightened twice in the sequence
shown.

Install the right-hand catalytic converter.

Install new retaining nuts.

Tighten in the sequence shown to 25 Nm.

23. Install the right-hand catalytic converter retaining bolts.

Tighten to 25 Nm.

24. Connect the right-hand heated oxygen sensor (HO2S) electrical

connector.

25. Connect the right-hand heated catalyst monitor sensor electrical

connector.

26. Install a new halfshaft snap ring.

27. Install a new halfshaft seal.

28.

CAUTION: Do not use excessive force when engaging the

halfshaft to the link shaft. Failure to follow this instruction may result in
damage to the component.

• NOTE: Make sure the halfshaft is fully located to the link shaft.

Install the halfshaft.

29. Install the transfer case Y bracket.

Tighten to 55 Nm.

30. Install the transfer case Y bracket retaining bolts.

Tighten to 25 Nm.

Vehicles with 2.0L engine

31. Install the halfshaft and intermediate shaft assembly.

Tighten to 20 Nm.

All vehicles

32.

CAUTION: Make sure the right-hand drive halfshaft is supported,

failure to follow this instruction may result in damage to the component.

Using the special tool, install the engine and transaxle to the subframe.

33. Install the engine roll restrictor.

Tighten to 80 Nm.

34. Install the engine roll restrictor retaining bolt.

Tighten to 80 Nm.

35. Remove the special tool.

36. Connect the power steering high-pressure pipe.

Install a new O-ring seal.

Tighten to 30 Nm.

37. Install the power steering high-pressure pipe retaining bolt.

Tighten to 25 Nm.

38. Install a new halfshaft snap ring.