Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 342
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Mass Air Flow (MAF) Sensor
Removal and Installation
Removal
1. Remove the battery cover.
2. Disconnect the MAF sensor electrical connector.
3. Remove the MAF sensor.
Installation
1. To install, reverse the removal procedure.
2. NOTE: For NAS vehicles only.
If required, carry out a short drive cycle.
For additional information, refer to:
Powertrain Control Module (PCM)
Short Drive Cycle Self-Test
(303-14A Electronic Engine Controls - 2.0L NA
V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27, General Procedures).
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Oil Temperature Sensor
Removal and Installation
Removal
1. Raise and support the vehicle.
For additional information, refer to Section
100-02 Jacking and Lifting
.
2. Remove and discard the oil filter.
3. Disconnect the oil temperature sensor electrical connector.
4. Remove the oil temperature sensor.
Installation
1. NOTE: Apply a small bead of sealant W SK-M4G328-A3 or equivalent
sealant meeting Jaguar specification on the first three threads of the oil
temperature sensor.
To install, reverse the removal procedure.
Tighten to 15 Nm.
2. Install a new oil filter.
3. NOTE: Use oil WSE-M2C908-A or equivalent meeting Jaguar
specification.
Check and top up the engine with oil.
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Throttle Position (TP) Sensor
Removal and Installation
Removal
Vehicles with 2.5L or 3.0L engine
1. For additional information, refer to Section
303-04A Fuel Charging and
Controls
Section
303-04B Fuel Charging and Controls
Section
303-04C
Fuel Charging and Controls - Turbocharger
.
Vehicles with 2.0L engine
2. Disconnect the battery
For additional information, refer to Section
414-01 Battery, Mounting
and Cables
.
3. NOTE: 2.5L and 3.0L shown, 2.0L similar.
Remove the engine cover.
4. NOTE: 2.5L and 3.0L shown, 2.0L similar.
Disconnect the air cleaner outlet pipe.
5. Disconnect the electrical connector.
6. Remove the the throttle position (TP) sensor.
Installation
1. To install, reverse the removal procedure.
2. Tighten to 7 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст