Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 340
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Fuel Temperature Sensor2.5L NA V6 - AJV6/3.0L NA V6 - AJ27
Removal and Installation
Special Tool(s)
Quick fit connector releasing tool
310-045
Removal
1. Remove the engine cover.
2. Remove the retaining clip from the spring lock coupling.
3. Disconnect the fuel temperature sensor electrical connector.
4. Using the special tool, remove the fuel temperature sensor.
Remove and discard the O-ring seal.
Installation
1. NOTE: Install a new O-ring seal.
Install the fuel temperature sensor.
2. Connect the fuel temperature sensor electrical connector.
3. Install the retaining clip to the spring lock coupling.
4. Install the engine cover.
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Heated Oxygen Sensor (HO2S) LH
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to Section
414-01 Battery, Mounting
and Cables
.
2. Raise and support the vehicle.
For additional information, refer to Section
100-02 Jacking and Lifting
.
3. Disconnect the heated oxygen sensor (HO2S) electrical connector.
4. Detach HO2S electrical connector from the securing bracket.
1. Release the retaining tang.
2. Detach HO2S electrical connector from the securing bracket.
5. CAUTIONS:
Do not cut the HO2S harness.
Make sure that the HO2S casing and harness is not damaged.
Using Snap-on socket S6176 remove the HO2S.
Installation
1.
CAUTION: Make sure that the HO2S casing and cable are not
damaged.
To install, reverse the removal procedure.
Tighten to 40 Nm.
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Heated Oxygen Sensor (HO2S) RH
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to Section
414-01 Battery, Mounting
and Cables
.
2. Disconnect the heated oxygen sensor (HO2S) electrical connector.
3. Detach HO2S electrical connector from the securing bracket.
1. Release the retaining tang.
2. Detach HO2S electrical connector from the securing bracket.
4. Turn the steering onto full right-hand lock.
5. Raise and support the vehicle.
For additional information, refer to Section
100-02 Jacking and Lifting
.
6. CAUTIONS:
Do not cut the HO2S harness.
Make sure that the HO2S casing and harness is not damaged.
Using Snap-on socket S6176 remove the HO2S.
Installation
1.
CAUTION: Make sure that the HO2S casing and harness is not
damaged.
To install, reverse the removal procedure.
Tighten to 40 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст