Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 338
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Camshaft Position (CMP) Sensor
Removal and Installation
Removal
1. Remove the engine cover.
2. Disconnect the CMP sensor electrical connector.
3. Remove the CMP sensor.
Remove and discard the O-ring seal.
Installation
1. NOTE: Install a new O-ring seal.
To install, reverse the removal procedure.
Tighten to 7 Nm.
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Catalyst Monitor Sensor LH
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and Connect
(414-01 Battery, Mounting and Cables, General Procedures).
2. Raise and support the vehicle. For additional information, refer to
For additional information, refer to:
Jacking
(100-02 Jacking and Lifting,
Description and Operation).
.
3. Detach the catalyst monitor sensor harness from the securing clip.
4. Disconnect the catalyst monitor sensor electrical connector.
5. Detach the catalyst monitor sensor electrical connector from the
securing bracket.
1. Release the retaining tang.
2. Detach the catalyst monitor sensor electrical connector from
the securing bracket.
6. CAUTIONS:
Do not cut the HO2S harness.
Make sure that the catalyst monitor sensor casing and harness is
not damaged.
Using Snap-on socket S6176 remove the catalyst monitor sensor.
Installation
1.
CAUTION: Make sure that the catalyst monitor sensor casing and
cable are not damaged.
To install, reverse the removal procedure.
Tighten to 40 Nm.
2. NOTE: For NAS vehicles only.
If required, carry out a long drive cycle.
For additional information, refer to:
Powertrain Control Module (PCM)
Long Drive Cycle Self-Test
(303-14A Electronic Engine Controls - 2.0L NA
V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27, General Procedures).
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Catalyst Monitor Sensor RH
Removal and Installation
Removal
1. Disconnect the battery ground cable.
For additional information, refer to:
Battery Disconnect and Connect
(414-01 Battery, Mounting and Cables, General Procedures).
2. Remove the intake manifold.
For additional information, refer to:
Intake Manifold
(303-01B Engine -
2.0L Duratorq-TDCi/2.2L Duratorq-TDCi (110kW /150PS) - Puma,
In-vehicle Repair).
3. Raise and support the vehicle. For additional information, refer to
For additional information, refer to:
Lifting
(100-02 Jacking and Lifting,
Description and Operation).
.
4. Undo and remove the exhaust shield securing bolt to allow access to
the catalyst monitor sensor.
5. Lower the vehicle.
6. Disconnect the catalyst monitor sensor electrical connector.
7. Detach the catalyst monitor sensor electrical connector from the
securing bracket.
1. Release the retaining tang.
2. Detach the catalyst monitor sensor electrical connector from
the securing bracket.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст