Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 339
8. CAUTIONS:
Do not cut the HO2S harness.
Make sure that the catalyst monitor sensor casing and cable are not
damaged.
Using Snap-on socket YA8875 remove the catalyst monitor sensor.
Installation
1.
CAUTION: Make sure that the catalyst monitor sensor casing and
cable are not damaged.
To install, reverse the removal procedure.
Tighten to 40 Nm.
2. NOTE: For NAS vehicles only.
If required, carry out a long drive cycle.
For additional information, refer to:
Powertrain Control Module (PCM)
Long Drive Cycle Self-Test
(303-14A Electronic Engine Controls - 2.0L NA
V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27, General Procedures).
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Crankshaft Position (CKP) Sensor
Removal and Installation
Removal
1. Remove the right-hand front road wheel. For additional information,
refer to Section
204-04 W heels and Tires
.
2. Remove the wheel arch liner access cover.
3. Disconnect the CKP sensor electrical connector.
4. Remove the CKP sensor.
Remove and discard the O-ring seal.
Installation
1. NOTE: Install a new O-ring seal.
To install, reverse the removal procedure.
Tighten to 10 Nm.
Published: 11-May-2011
Electronic Engine Controls - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 -
Engine Control Module (ECM)
Removal and Installation
Removal
1. Disconnect the battery ground cable. For additional information, refer to
For additional information, refer to:
Battery Disconnect and Connect
(414-01 Battery, Mounting and Cables, General Procedures).
2. Remove the engine wiring harness trim panel.
3. Disconnect the engine control module (ECM) electrical connector.
4. Remove the instrument cluster lower trim panel.
5. Remove the trim panel.
6. Detach the generic electronic module (GEM) from the ECM.
1. Release the GEM locking tang.
2. Detach the GEM from the ECM.
7. Remove the ECM.
1. Remove the ECM retaining nut.
2. Remove the ECM.
8. Remove the ECM from the ECM retaining bracket.
Installation
1. To install, reverse the removal procedure.
Tighten to 10 Nm.
2.
CAUTION: Make sure that the electrical connector locates correctly
in the ECM. Do not force or overtighten the electrical connector.
Tighten to 10 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст