Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 667
Published: 11-May-2011
Bumpers - Rear Bumper Cover4-Door
Removal and Installation
Removal
All Vehicles
1. Raise and support the vehicle. For additional information, refer to
Section
100-02 Jacking and Lifting
.
2. Detach the rear wheel arch liner.
Right-hand side shown, left-hand side similar.
3. Detach the side of the bumper cover.
Right-hand side shown, left-hand side similar.
4. Detach the boot liner.
Right-hand side shown, left-hand side similar.
5. Remove the luggage compartment rear trim panel.
6. Remove the spare wheel.
Vehicles with parking aid
7. Disconnect the electrical connector.
All vehicles
8. Disconnect the electrical connector.
9. Detach the grommet.
10. Detach the side of the bumper cover.
11. Detach the side of the bumper cover.
12.
CAUTION: Make sure the bumper cover is supported before
removing the securing nuts.
Remove the bumper cover securing nuts.
13. Remove the bumper cover.
Installation
1. To install, reverse the removal procedure.
2. Tighten to 7 Nm.
3. Tighten to 7 Nm.
4. Tighten to 7 Nm.
5. Tighten to 7 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст