Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 151

8. Tighten to 25 Nm,

9. Tighten to 55 Nm.

10. Tighten to 55 Nm.

Vehicles with 2.5L or 3.0L engine

11. Install the transfer case. For additional information, refer to Section

308-07 Transfer Case

.

All vehicles

12. NOTE: Use oil WSE-M2C908-A or equivalent meeting Jaguar
specification.

Refill the engine with oil.

Published: 11-May-2011

Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Oil Pressure
Sender

In-vehicle Repair

Removal

1. Raise and support the vehicle.

For additional information, refer to Section

100-02 Jacking and Lifting

.

2. Remove and discard the oil filter.

3. Disconnect the oil pressure sender electrical connector.

4. Remove the oil pressure sender.

Installation

1. NOTE: Apply a small bead of sealant W SK-M4G328-A3 or equivalent
sealant meeting Jaguar specification on the first three threads of the oil
pressure sender.

To install, reverse the removal procedure.

Tighten to 15 Nm.

2. Install a new oil filter.

3. NOTE: Use oil WSE-M2C908-A or equivalent meeting Jaguar
specification.

Check and top up the engine with oil.

Published: 11-May-2011

Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Oil Pump

In-vehicle Repair

Removal

1. Remove the timing chains. For additional information, refer to

Timing

Drive Components

.

2. Remove and discard the engine oil filter.

3. Remove the oil pump tube.

4. Remove the oil pump.

Remove and discard the O-ring seal.

Inspect the oil pump for damage and wear.

Installation

1. CAUTIONS:

Install the oil pump flush to the cylinder block for correct sealing.

Rotate the inner rotor of the oil pump to align with the flats on the

crankshaft before installation.

Install the oil pump.

Tighten to 10 Nm.

2. Install the oil pump tube.

Install a new O-ring seal.

Tighten to 10 Nm.

3. Tighten to 5 Nm + 45°.

4. Install a new engine oil filter.

5. Install the timing chains. For additional information, refer to

Timing

Drive Components

.