Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 149

2. Connect the fuel injector harness electrical connector.

3. Install the engine cover retaining bracket (if equipped).

Vehicles with 2.0L engine

4. Connect the engine coolant temperature (ECT) electrical connector.

Attach the harness.

Vehicles with 2.5L or 3.0L engine

5. Connect the fuel pressure sensor electrical connector.

6. Connect the engine coolant temperature (ECT) and fuel temperature

sensor electrical connectors.

7. Connect the spring lock coupling.

For additional information, refer to:

Spring Lock Couplings

(310-00 Fuel

System - General Information, General Procedures).

8. Install the intake manifold.

For additional information, refer to:

Intake Manifold

(303-01A Engine -

2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27, In-vehicle
Repair).

Published: 11-May-2011

Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Oil Cooler

In-vehicle Repair

Removal

1. Drain the cooling system. For additional information, refer to Section

303-03A Engine Cooling

Section

303-03B Engine Cooling

.

2. Drain the engine oil.

3. Remove and discard the engine oil filter.

4. Detach the inlet and outlet coolant hoses.

5. Remove the oil cooler.

Remove the oil cooler retaining bolt.

Remove and discard the oil cooler O-ring seal.

Installation

1. To install reverse the removal procedure.

2. NOTE: Make sure the oil cooler locating tag is correctly located.

Install the oil cooler.

Install a new oil cooler O-ring seal.

Install the oil cooler retaining bolt.

Tighten to 57 Nm.

Published: 11-May-2011

Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Oil Pan

In-vehicle Repair

Special Tool(s)

Accessory Belt Detensioner

303-703

Removal

All vehicles

1. Drain the engine oil.

Vehicles with 2.5L or 3.0L engine

2. Remove the transfer case. For additional information, refer to Section

308-07 Transfer Case

.

Vehicles with 2.0L engine

3. Detach the exhaust link pipe rear retaining clamp.

4. Remove the link pipe.

5. Remove the catalytic converter retaining bracket.