Jaguar X-Type Sedan and Estate (Wagon). Service manual — part 148
20. Attach the throttle cable.
1. Reposition the throttle lever to the fully open position.
2. Attach the throttle cable.
21. Attach the cruise control cable.
22. Attach the positive crank case ventilation hose.
23. Fill the cooling system up to the MAX mark on the coolant expansion
tank using a fifty percent mixture of Jaguar Premium Cooling System
Fluid or equivalent, meeting Jaguar specification WSS M97B44-D and
fifty percent water.
Vehicles with 2.5L or 3.0L engine
24. Install the air cleaner resonator.
25. Install the positive crankcase ventilation hose.
All vehicles
26. Install the air filter outlet pipe.
For additional information, refer to:
Air Cleaner Outlet Pipe
(303-12A
Intake Air Distribution and Filtering - 2.0L NA V6 - AJV6/2.5L NA V6 -
AJV6/3.0L NA V6 - AJ27, Removal and Installation).
27. Install the engine cover (if equipped).
Published: 11-May-2011
Engine - 2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27 - Lower Intake
Manifold
In-vehicle Repair
Removal
All vehicles
1. Remove the intake manifold.
For additional information, refer to:
Intake Manifold
(303-01A Engine -
2.0L NA V6 - AJV6/2.5L NA V6 - AJV6/3.0L NA V6 - AJ27, In-vehicle
Repair).
2. Disconnect the spring lock coupling.
For additional information, refer to:
Spring Lock Couplings
(310-00 Fuel
System - General Information, General Procedures).
Vehicles with 2.5L or 3.0L engine
3. Disconnect the engine coolant temperature (ECT) and fuel temperature
sensor electrical connectors.
4. Disconnect the fuel pressure sensor electrical connector.
Vehicles with 2.0L engine
5. Disconnect the engine coolant temperature (ECT) electrical connector.
Detach the harness.
All vehicles
6. Remove the engine cover retaining bracket (if equipped).
7. Disconnect the fuel injector harness electrical connector.
8.
W ARNING: Fuel may still be present in the fuel injection supply
manifold.
• NOTE: Remove and discard the lower intake manifold O-ring seals.
Remove the lower intake manifold.
Installation
All vehicles
1. NOTE: Install new O-ring seals.
Install the lower intake manifold.
Tighten the retaining bolts in the sequence shown.
Tighten to 10 Nm.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст