Chery QQ6 (Body Accessories and Dimensions). Service Instruction — part 9
129
2.1.3. Remove the connectors from the ignition coil.
2.1.4. Remove the connector from the camshaft sensor.
2.1.5. Remove the connector from the cansiter solenoid
valve connector.
2.1.6. Remove the connector from the air pressure
sensor.
2.1.7. Remove four connectors from the injector
nozzle.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
130
2.1.8. Remove the connector from the charging
indicator.
2.1.9. Remove the connector from the generator.
2.1.10. Remove the starter connector and battery
connector.
2.1.11. Pull out the connector from the A/C
compressor.
2.1.12. Remove the connector from the oil pressure
switch.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
131
2.1.13. Remove the connector from the power steering
pump.
2.1.14. Remove the connector from the knock sensor.
2.1.15. Remove the connector from the backup lamp
switch.
2.1.16. Remove the connector from the water
temperature sensor.
2.1.17. Remove the connector from the front rear
oxygen sensor.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
132
2.1.18. Remove the connector from the vehicle speed
sensor.
2.1.19. Remove the connector from the engine speed
sensor.
2.1.20. Take off the electronic injector harness assy.
2.2. Installation
Install it in the reverse order of removal.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
133
Section 4 Interior Harness
I. Schematic Diagram of Harness
Ground C
Ground A
To Back Door Harness
Rear Left Door Contact Switch
Rear Left Tail Lamp
Rear Trunk Lamp
Rear Left Wheel Sensor
To Fuel Pump
To Rear Left Door Harness Connector A
Rear Right Tail Lamp
Ground B
Rear Right Door Contact Switch
Rear Right Wheel Sensor
To Rear Left Door Harness Connector B
To Front Left Door
Harness Connector A
To Front Left Door
Harness Connector B
To Ceiling Lamp
Main Seat
Belt Switch
Auxiliary Seat
Belt Switch
Front
Left
Door Contact
Switch
Hand Brake Switch
Window Regulator Module B
Window Regulator Module A
Window Regulator Module B
Window Regulator Module A
To Engine Compartment Harness
To Rear Right Door
Harness Connector B
To Rear Right Door
Harness Connector A
Front
Right
Door Contact
Switch
To Instrument Harness Connector A
To Instrument Harness Connector B
To Front Right Door Harness
Ground
-------------------------------------------------------------------------------------------------------------------------------------------------------------
134
II. Main Connectors Description
No
Connector Description
Number
of Pin
Connection
Remark
1
To front right door harness connector
16
Front right door harness
2
Right tail lamp connector
6
Right tail lamp harness
3
Front right door contact switch
connector
1
Front right door contact
switch
4
To rear right door harness connectorA
3
Rear right door harnessA
5
To rear right door harness connectorB
8
Rear right door harnessB
6
Rear right wheel sensor connector
2
Rear right wheel sensor
7
Rear right door contact switch
connector
1
Rear right door contact
switch
8
Ground B
1
Body
At upper of rear right
wheelhouse paintwork
9
To instrument harness connectorA
26
Instrument harness A
10
To instrument harness connectorB
8
Instrument harness B
11
To engine compartment harness
connector
16
Engine
compartment
harness
12
To front left door harness connector
B
8
Front left door harness B
13
To front left door harness connector
A
16
Front left door harness A
14
Ground A
1
Body
Under left A pillar
15
Auxiliary seat belt switch connector
2
Auxiliary
seat
belt
switch
16
Hand brake switch connector
1
Hand brake switch
17
Main seat belt switch connector
2
Main seat belt switch
18
Window Glass Regulator Module B
connector
25
Window Glass Regulator
Module B
19
Window Glass Regulator Module A
connector
16
Window Glass Regulator
Module A
20
Ground D
1
Body
At left side of window
regulator module
21
Connect to ceiling lamp connector
2
Ceiling lamp harness
22
Front left door contact switch
connector
1
Front left door contact
switch
23
To rear left door harness connector B
8
Rear left door harness B
24
To rear left door harness connector A
3
Rear left door harness A
25
To fuel pump connector
4
Fuel pump harness
26
Rear left wheel sensor connector
2
Rear left wheel sensor
27
Rear
left
door
contact
switch
connector
1
Rear left door contact
switch
28
Rear trunk lamp connector
2
Rear trunk lamp harness
29
To back door harness connector
6
Back door harness
30
Ground C
1
Body
At rear paintwork of
rear left wheelhouse
31
Left tail lampconnector
6
Left tail lamp harness
-------------------------------------------------------------------------------------------------------------------------------------------------------------
135
III. Disassembly/Reassembly of Interior
Floor Harness
Part Number: S21-3724050
(I). Preparation
Tools:
Socket
wrench,
cross
screwdriver,
flat
head
screwdriver
(II). Precautions
Power OFF before the electrical elements and
harnesses are removed.
The ignition switch must be in OFF state.
(III). Removal Procedure
1. Removal of Harness at Left Side of Interior Floor.
1.1.1. Remove the lower left guard plate from the
instrument panel. (See Disassembly/Reassembly of
Instrument Panel)
1.1.2. Pull out the connector to the engine
compartment harness.
1.1.3. Pull out the connector A to the instrument
harness.
1.1.4. Pull out the connector B to the instrument
harness.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
136
1.1.5. Remove the A pillar lower trim with a cross
screwdriver.
1.1.6. Pull out the connector of front left door harness
A.
1.1.7. Pull out the connector of front left door harness
B.
1.1.8. Remove the grounding point. (under the A pillar)
1.1.9.
Remove
the
console.
(See
Disassembly/Reassembly of Console)
1.1.10. Remove the connector from the hand brake
switch.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
137
1.1.11. Remove the connector from main seat belt
switch.
1.1.12.
Remove
the
seat
and
carpet.
(See
Disassembly/Reassembly of Seat and Carpet)
1.1.13. Pull out two connectors A and B of the window
regulator.
1.1.14. Remove the grounding point.
1.1.15.
Remove
the
B
pillar
trim.
(See
Disassembly/Reassembly of Seat Belt)
1.1.16. Remove the front left door contact switch.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
138
1.1.17. Pull out the connectors A and B to the right and
left rear door harnesses.
1.1.18.
Remove
the
ceiling.
(See
Disassembly/Reassembly of Ceiling)
1.1.19. Pull out the ceiling lampconnector.
1.1.20.
Remove
the
rear
seat.
(See
Disassembly/Reassembly of Rear Seat)
1.1.21. Take off the upper protecting cover of oil pump.
1.1.22. Pull out the connector to the fuel pump.
1.1.23. Pull out the connector of rear left wheel speed
sensor.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
139
1.1.24.
Remove
the
C
pillar
trim.
(See
Disassembly/Reassembly of Ceiling)
1.1.25. Pull out the rear left door contact switch.
1.1.26. Pull out the connector to the back door harness.
1.1.27. Pull out the connector of rear trunk lamp.
1.1.28. Remove the left grounding point from the
luggage boot.
1. 1.29. Remove the connector of left tail lamp.
1.2 Install it in the reverse order of removal.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
140
2. Removal of harness at right side of interior floor.
2.1.1.
Remove
the
glove
case.
(See
Disassembly/Reassembly of Instrument Panel)
2.1.2. Pull out the connector of front right door
harness.
2.1.3. Remove the right B pillar trim. (See
Disassembly/Reassembly of Seat Belt)
2.1.4. Pull out the connector of front right door contact
switch.
2.1.5. Pull out the connectors A and B of rear right
door harness.
2.1.6. Pull out the connector of auxiliary seat belt
switch.
2.1.7. Pull out the connector of rear right wheel speed
sensor.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
141
2.1.8.
Remove
the
C
pillar
trim.
(See
Disassembly/Reassembly of Ceiling)
2.1.9. Pull out the rear right door contact switch.
2.1.10. Remove the grounding point.
2.1.11. Take off the upper protecting cover of oil
pump.
2.1.12. Pull out the connector of right tail lamp.
2.2. Installation.
Install it in the reverse order of removal.
-------------------------------------------------------------------------------------------------------------------------------------------------------------
142
Section 5 Instrument Harness Assy
I. Schematic Diagram of Harness
To Engine Compartment Harness A
To Engine Compartment
Harness B
To Engine Compartment
Harness C
To Interior Harness Connector A Black
Self-Diagnostic
Stop Switch
Electric Rear-View
Mirror Switch
Combination Instrument
To Antenna
To A/C Harness
Ground A
Panel Indicator
Anti-theft Indicator
Ground B
Defroster
Switch
Cigarette
Lighter
Fan Switch
Alarm Switch
A/C Switch
Horn Switch
Radio
Air Bag Connector
Clutch Switch
Wiper Switch
(Combination Switch)
Fog Lamp Switch
(Combination Switch)
Turn Signal Dimmer Switch
(Combination Switch)
Anti-theft
Indicator
Nightlight Switch
Headlamp Switch
Ignition Switch
To Interior Harness Connector B
Instrument Electrical Box
Ground C
-------------------------------------------------------------------------------------------------------------------------------------------------------------
143
II. Definition of Main Connectors
Connector
Pin
Connect to
1
Nightlight Switch
2
233(JOINT: Ground or power positive, the same below)
3
234(JOINT)
4
248(JOINT)
5
Combined Instruments
6
Wiper Intermittern Relay
7
138(JOINT)
8
Wiper Switch(combination switch)
9
Wiper Switch(combination switch)
10
90(JOINT)
11
A/C Switch
12
Connect to the instrument electrical box
13
253(JOINT)
14
253(JOINT)
15
247(JOINT)
16
Turn signal dimmer switch (combination switch)
17
Turn signal dimmer switch (combination switch)
18
Combined Instruments
19
Combined Instruments
20
Connect to A/C harness
21
Fan Switch
22
116(JOINT)
23
Connect to A/C harness
24
Punch the card at the location near the diagnostic connector
25
Brake lamp Switch
Connect to
engine
compartme
nt harness A
26
Combined Instruments
1
Instrument Electric Device Box
2
Ignition Switch
Connect to
engine
compartme
nt harness C
3
Instrument Electrical Box f18
1
Clutch switch
2
Punch the card at the location near the diagnostic connector
3
Instrument Electrical Box f13
4
9(JOINT)
5
Instrument Electrical Box f12
6
Combined Instruments
7
To Instrument Electrical Box
8
Instrument Electrical Box f14
Connect to
engine
compartme
nt harness B
9
Instrument Electrical Box f16
-------------------------------------------------------------------------------------------------------------------------------------------------------------
144
10
Combined Instruments
11
Combined Instruments
12
Combined Instruments
13
Combined Instruments
14
Combined Instruments
15
Combined Instruments
16
Instrument Electric Device Box
1
271(JOINT)
2
Connect to interior harness B
3
Connect to interior harness B
4
Connect to interior harness B
5
Connect to interior harness B
6
Connect to interior harness B
7
138(JOINT)
8
302(JOINT)
9
——
Electric
Rearview
Mirror
Switch
10
——
1
Audio device
2
Audio device
3
140(JOINT)
4
Combined Instruments
5
Combined Instruments
6
Combined Instruments
7
Combined Instruments
8
9(JOINT)
9
Instrument Electric Device Box
10
Instrument Electrical Box f18
11
142(JOINT)
12
Anti-theft indicator
13
——
14
Audio device
15
Audio device
16
Audio device
17
Audio device
18
271(JOINT)
19
Instrument Electrical Box f17
20
Audio device
21
Audio device
22
Defroster Switch;
23
234(JOINT)
24
233(JOINT)
25
90(JOINT)
Connect to
the interior
harness
connectorA
(black)
26
——
-------------------------------------------------------------------------------------------------------------------------------------------------------------
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст