Chery Tiggo 5 (T21). Service manual — part 501
47–
20
47
Installation
Installation is in the reverse order of removal.
CAUTION
Try to prevent body paint surface from being scratched when installing hood cable assembly.
After installation of hood cable assembly is completed, make sure hood can be opened smoothly without
sticking.
47–
21
47
Hood Air Spring Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the hood left air spring assembly.
a. Using a screwdriver wrapped with protective tape, pry
up the fixing clip on the upper part of hood air spring.
b. Using a screwdriver wrapped with protective tape, pry
up the fixing clip on the lower part of hood air spring
and remove the hood left air spring assembly.
4. Remove the hood air spring ball pin (arrow).
(Tightening torque: 10 ± 1 N·m)
WARNING
When removing hood air spring assembly, an assistant is needed to hold hood. Prevent hood from
dropping or sudden closing to cause accidents during operation.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing hood air spring assembly.
Try to prevent body paint surface from being scratched when removing hood air spring assembly.
When removing hood air spring assembly, prevent hood from dropping to damage body or front
windshield during operation.
RT21470190
RT21470191
47–
22
47
Installation
Installation is in the reverse order of removal.
WARNING
When removing hood air spring assembly, an assistant is needed to hold hood. Prevent hood from
dropping or sudden closing to cause accidents during operation.
CAUTION
Try to prevent body paint surface from being scratched when installing hood air spring assembly.
Make sure hood air spring assembly and hood air spring clip are fitted closely after installing hood air
spring assembly.
47–
23
47
Front Door Protector Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the front left door inner triangular block assembly.
a. Using an interior crow plate, pry up the claws on front
door inner triangular block assembly, and remove the
front left door inner triangular block assembly.
4. Remove the front left door inside handle assembly.
a. Using a screwdriver wrapped with protective tape, pry
up the front door inside handle screw cover (1).
b. Remove the fixing screw (2) from the front door inside
handle assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
CAUTION
Be sure to wear safety equipment to prevent accidents when removing front door protector assembly.
Avoid damage to front door protector surface when removing front door protector assembly.
RT21470200
RT21470210
2
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст