Chery Tiggo 5 (T21). Service manual — part 184

15–

Passive Entry & Passive Start (PEPS) Controller (w/ PEPS System)

Removal

1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the glove box assembly (

See page 45-17

4. Remove the PEPS controller.

a. Disconnect the PEPS controller connectors (1).
b. Remove 2 fixing nuts (arrow) from PEPS controller

bracket.



(Tightening torque: 7 ± 1 N·m)

c. Remove the PEPS controller with bracket from engine crossmember.

Installation

Installation is in the reverse order of removal.

CAUTION

 Be sure to wear necessary safety equipment when repairing to prevent accidents.
 Try to prevent vehicle protector from being scratched during removal and installation.

RT21450480

CAUTION

 DO NOT separate PEPS controller and bracket if not as necessary. DO NOT separate them over and

over again if it is necessary to separate, to avoid damage to claws of PEPS controller.

CAUTION

 It is necessary to match the PEPS controller after replacing it (

See page 15-71

 With PEPS controller not matched, do not carelessly turn on and off the power, as the non-matched

PEPS controller has 50 chances to turn the power from off to ignition state, PEPS controller will not be
used once more than 50 times.

15–

Была ли эта страница вам полезна?

Да!Нет

9 посетителей считают эту страницу полезной.

Chery Tiggo 5 (T21). Service manual — part 184

Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.