Chery Tiggo 5 (T21). Service manual — part 342
31–
72
31
A/C Element
Removal
1. Remove the glove box assembly (
).
2. Remove the A/C element.
a. Detach the claws on both sides of A/C element cover,
and remove the A/C element cover (arrow) from the
air inlet assembly.
b. Pull out the A/C element (arrow) slowly from the air
inlet assembly.
Installation
Installation is in the reverse order of removal.
RT21310110
RT21310120
CAUTION
Be sure to check the A/C element for dirt during installation. Clean as necessary.
If A/C element is too dirty or damaged, replace with a new one.
31–
73
31
Blower Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the blower assembly.
a. Disconnect the blower assembly connector (arrow).
b. Detach the fixing claw (arrow) from the blower
assembly.
c. Rotate the blower assembly lightly to remove it.
Inspection
1. Check the blower motor.
a. Remove the blower assembly.
b. Connect the positive (+) battery lead to terminal 1 and
negative (-) battery lead to terminal 2. Check that the
blower motor operates smoothly.
If operation is not as specified, replace the blower assembly.
Installation
Installation is in the reverse order of removal.
RT21310130
RT21310140
1
2
-
+
RT21310150
31–
74
31
Blower Speed Resistor
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the blower speed resistor.
a. Disconnect the blower speed resistor connector
(arrow).
b. Detach the fixing claw (arrow) from the blower speed
resistor.
c. Remove the blower speed resistor.
Installation
Installation is in the reverse order of removal.
WARNING
During normal operation, the blower speed resistor may be very hot. Turn off the blower and wait for a
few minutes to cool the blower speed resistor before diagnosing or servicing, in order to avoid burns.
CAUTION
DO NOT operate the blower assembly when removing blower speed resistor from vehicle. Failure to do
so may result in damage to the blower assembly.
RT21310160
RT21310170
31–
75
31
AIR CONDITIONING
Inner/Outer Circulation Damper Motor
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the glove box assembly (
).
4. Remove the inner/outer circulation damper motor.
a. Disconnect the inner/outer circulation damper motor
connector (arrow).
b. Detach the fixing claw, and remove the inner/outer
circulation damper motor (arrow) from the air inlet
assembly carefully.
Installation
Installation is in the reverse order of removal.
RT21310190
RT21310200
CAUTION
When installing, apply a small amount of grease to the contact surface between inner/outer circulation
damper motor lever and inner/outer circulation damper set to ensure the motor operates smoothly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст