Chery Tiggo 5 (T21). Service manual — part 343
31–
76
31
Mode Damper Servo Motor
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the mode damper servo motor.
a. Disconnect the mode damper servo motor connector
(arrow).
b. Detach the fixing claw, and remove the mode damper
servo motor (arrow) from the evaporator tank
assembly carefully.
Installation
Installation is in the reverse order of removal.
RT21310220
RT21310230
CAUTION
When installing, apply a small amount of grease to the contact surface between mode damper servo
motor lever and mode damper adjustment mechanism set to ensure the motor operates smoothly.
31–
77
31
Mix Damper Servo Motor
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the mix damper servo motor.
a. Disconnect the mix damper servo motor connector
(arrow).
b. Detach the fixing claw, and remove the mix damper
servo motor (arrow) from the evaporator tank
assembly carefully.
Installation
Installation is in the reverse order of removal.
RT21310240
RT21310250
CAUTION
When installing, apply a small amount of grease to the contact surface between mix damper servo motor
lever and mix damper adjustment mechanism set to ensure the motor operates smoothly.
31–
78
31
HVAC Assembly
Removal
1. Recover the refrigerant from the A/C system (
).
2. Turn off all the electrical equipment and ignition switch.
3. Disconnect the negative battery cable.
4. Remove the steering wheel assembly (
5. Remove the steering column (
6. Remove the instrument panel body assembly (
7. Remove the instrument panel crossmember assembly (
8. Remove the HVAC assembly.
a. Remove the fixing bolt (arrow) between A/C high/low
pressure line and expansion valve, and detach the A/C
high/low pressure line.
(Tightening torque: 7 ± 1 N·m)
b. Using snap spring calipers, disengage the fixing
clamps (arrow) from the heating inlet hose and
heating outlet hose, and disengage the heating inlet
and outlet hoses.
CAUTION
Special service equipment for R134a refrigerant must be used to recover/charge refrigerant.
Be careful not to damage hoses during removal and installation.
Always keep the work area in good ventilation.
The disconnected A/C line and connecting part should be sealed to prevent foreign matter from entering.
RT21310260
RT21310270
31–
79
31
c. Remove 4 fixing nuts and 2 fixing bolts (arrow)
between HVAC assembly and instrument panel
crossmember assembly.
(Tightening torque for nut: 7 ± 1 N·m)
(Tightening torque for bolt: 4 ± 1 N·m)
d. Remove 2 fixing bolts (arrow) between HVAC
assembly and body.
(Tightening torque: 7 ± 1 N·m)
e. Remove the instrument panel wire harness assembly
fixing clips (arrow) from the HVAC assembly.
f. Disengage the A/C drain pipe (arrow) from the body
positioning hole.
RT21310280
RT21310290
RT21310300
RT21310310
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст