Chery Tiggo 5 (T21). Service manual — part 122
07–
74
07
b. Remove the fixing bolt (arrow) and move away the
bracket II from transmission.
(Tightening torque: 15 ± 2 N·m)
c. Remove the fixing bolt (arrow) and move away the
bracket I from transmission.
(Tightening torque: 15 ± 2 N·m)
33.Move away the transmission ground wire.
a. Remove the transmission ground wire fixing bolt
(arrow) and move away the transmission ground wire
(for MT model).
(Tightening torque: 15 ± 2 N·m)
b. Remove the transmission ground wire fixing bolt
(arrow) and move away the transmission ground wire
(for CVT model).
(Tightening torque: 15 ± 2 N·m)
RT21070780
RT21070781
RT21070790
RT21070791
07–
75
07
34.Disconnect the steering pump line (w/ hydraulic assist steering).
a. Remove the hollow bolt (arrow) from high pressure
pipe and move away the steering pump line from
steering pump.
(Tightening torque: 45 ± 5 N·m)
35.Disconnect the A/C line.
a. Remove 2 fixing bolts (arrow) between A/C high/low
pressure line and compressor assembly, and
disengage the A/C high/low pressure line from
compressor assembly.
(Tightening torque: 25 ± 2.5 N·m)
36.Disconnect the engine wire harness.
a. Disconnect the engine wire harness connector (arrow)
and move the engine wire harness away from the wire
harness clip (1).
b. Remove the battery wire harness ground wire fixing
bolt (arrow) and move away the battery wire harness
ground wire.
RT21070792
RT21310860
1
RT21070800
RT21070810
07–
76
07
c. Open the fuse and relay box cover, remove the
battery wire harness fixing nut (arrow), and disconnect
the connection between battery wire harness and fuse
and relay box.
(Tightening torque: 7 ± 1 N·m)
d. Remove the fuse and relay box and disconnect 2 engine wire harness connectors.
37.Disconnect the CVT connector (for CVT model).
a. Disconnect the second shaft pressure sensor (1).
b. Disconnect the second shaft speed sensor (2).
c. Disconnect the connector B (1).
d. Disconnect the connector A (2).
e. Disconnect the clutch speed sensor (3).
f. Disconnect the primary shaft speed sensor (4).
g. Disconnect the primary shaft pressure sensor (arrow).
38.Use an engine equalizer to hang the engine.
39.Remove the engine rear mounting assembly (
40.Remove the engine front mounting assembly (
).
41.Remove the engine equalizer and use an engine hoist to hang the lifting eyes on both sides of the engine.
42.Remove the engine left mounting cushion assembly (
RT21070820
2
1
RT21070830
4
3
2
1
RT21070840
RT21070850
07–
77
07
43.Remove the engine right mounting cushion assembly (
).
44.Confirm that all the components are disconnected from engine.
45.Hang the engine with transmission out of engine compartment.
46.Remove the engine wire harness and battery wire harness from engine.
47.Separate the engine and the transmission.
48.Install the engine on the engine service platform.
Installation
Installation is in the reverse order of removal.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст