Peugeot 2008 (2016 year). Instruction — part 18
271
.
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Towards a recent destination
Select "Enter destination".
Select an address from
the list offered.
Press on Navigation to display the
primary page.
Press on the secondary page.
Select "Navigate to".
Towards a contact
Select "Enter destination".
Select "Contacts".
Press on Navigation to display the
primary page.
Press on the secondary page.
Select a destination from
the contacts in the list
offered.
Select "Navigate to".
Select the criteria then "Confirm" to
start navigation.
To be able to use navigation "towards
a contact in the directory", it is first
necessary to enter the address for your
contact.
Select the criteria then "Confirm" or
press "Show route on map" to start
navigation.
272
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Towards GPS coordinates
Select "Enter destination".
Select "Address".
Enter the "Longitude:"
then the "Latitude:".
Select "Navigate to".
Select the criteria then "Confirm" or
press "Show route on map" to start
navigation.
Press on Navigation to display the
primary page.
Press on the secondary page.
Towards a point on the map
Select "Enter destination".
Select "On the map".
Press on Navigation to display the
primary page.
Press on the secondary page.
Zooming in on the map shows points with
information.
A long press on a point opens its content.
Towards points of interest (POI)
Points of Interest (POI) are listed in different
categories.
Press on Navigation to display the
primary page.
Press on the secondary page.
Select "Search for POI".
Select "All POIs",
Or
"Motor",
Or
"Dining/hotels".
273
.
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
An annual mapping update allows new
points of interest to be presented to
you.
You can also update the Risk areas /
Danger areas every month.
The detailed procedure is available on:
http://peugeot.navigation.com.
274
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Risk areas / Danger zone
alert settings
Press on Navigation to display the
primary page.
Press on the secondary page.
Select "Settings".
Select "Alarm!" (Alert).
It is then possible to activate Risk areas alerts
then:
-
"Audible warning"
-
"Alert only when navigating"
-
"Alert only for overspeed"
-
"Display speed limits"
-
Timing: the choice of timing allows the
time before giving a Risk areas alert to be
defined.
Select "Confirm".
This series of alerts and displays is
only available if Risk areas have first
been downloaded and installed on the
system.
Traffic
Traffic information
Display of messages
Press on Navigation to display the
primary page.
Press on the secondary page.
Select "Traffic messages".
Choose filter settings for:
"On the route",
"Around",
"Near destination", filters to fine-
tune the list of messages.
Press again to remove the filter.
275
.
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Select the message from
the list offered.
Select the magnifying glass to have
voice information.
Setting filters
Press on Navigation to display the
primary page.
Press on the secondary page.
Select "Settings".
Select "Traffic options".
Select:
- "Be advised of new messages",
- "Speak messages".
Then enter the filter radius.
Select "Confirm".
We recommend a filter radius of:
-
12 miles (20 km) in urban areas,
-
30 miles (50 km) on motorways.
TMC (Traffic Message Channel)
messages on GPS-Navigation contain
traffic information transmitted in real
time.
The TA (Traffic Announcement)
function gives priority to TA alert
messages. To operate, this function
needs good reception of a radio station
transmitting this type of message.
When a traffic report is transmitted,
the current audio source is interrupted
automatically to play the TA message.
Normal playback of the audio source
resumes at the end of the transmission
of the message.
Receiving TA messages
Press on Navigation to display the
primary page.
Press on the secondary page.
Select "Settings".
Select "Voice".
Activate / Deactivate "Traffic
(TA)".
276
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Radio Media
Level 1
Level 2
List of FM stations
Save
277
.
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Level 1
Level 2
Comments
Radio Media
List
List of FM stations
Press on a radio station to select it.
Radio Media
Source
FM Radio
Select change of source.
DAB Radio
AM Radio
USB
CD
MirrorLink
TM
CarPlay
®
iPod
Bluetooth
AUX
Jukebox
Radio Media
Save
Press an empty location to Save it.
278
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Level 1
Level 2
Level 3
Media
Photos
Manage Jukebox
List of FM stations
Copy to Jukebox
279
.
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Level 1
Level 2
Level 3
Comments
Radio Media
Secondary page
Radio list
Save
Press a radio station to select it.
Update list
Update the list of stations received.
Frequency
Enter the desired radio frequency.
Confirm
Save the settings.
Radio Media
Secondary page
Photos
Home screen
Display the selected photo in the home page.
Rotate
Rotate the photo 90°.
Select all
Select all the photos in the list.
Press again to deselect.
Slideshow
Previous photo.
Display the photos in sequence, full screen.
The system supports the following image formats:
.gif, .jpg, .bmp, .png.
Pause / Play.
Next photo.
Full screen
Display the selected photo full-screen.
Radio Media
Secondary page
Manage Jukebox
Sort by folder
Choose a selection mode.
Sort by album
Select all
Copy
Copy files to the Jukebox.
Magnifying glass
Create folder
Choose the desired function.
Rename
Delete
Select all
Confirm
Save the settings.
280
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Level 1
Level 2
Level 3
Media
Settings
Settings
Settings
281
.
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Level 1
Level 2
Level 3
Comments
Radio Media
Secondary page
Media list
Presentation of the last media used.
Radio Media
Secondary page
Settings
Media
Settings
Shuffle (all tracks)
Choose the play settings.
Shuffle (current album)
Repeat
Aux. amplification
Radio
Settings
RDS options
Activate or deactivate the settings.
DAB/FM station tracking
Display Radio Text
Digital radio slideshow
display
Announcements
Settings
Traffic announcements (TA)
Activate or deactivate the settings.
News - Weather
Sport - Programm info
Flash - Unforeseen
events
Confirm
Save the settings.
282
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Press on Radio Media to display the
primary page.
Press on Radio Media to display the
primary page.
Select "Save".
If necessary, select change of
source.
Press on Radio Media to display the
primary page.
Select change source.
"AM Radio".
By automatic frequency search
Select "FM Radio".
"AM Radio".
Press on Radio Media to display the
primary page.
Select a preset radio station
in the list.
Select "FM Radio".
Select a radio station from
the list offered.
Select "Update list" to refresh the
list.
Press on the secondary page.
Or
Radio
Changing a radio frequency
Selecting a station
To select a preset radio station.
THEN
Radio reception may be affected by
the use of electrical equipment not
approved by PEUGEOT, such as a USB
charger connected to the 12 V socket.
The exterior environment (hills,
buildings, tunnel, car park, below
ground...) may prevent reception,
even in RDS station tracking mode.
This phenomenon is normal in the
propagation of radio waves and is in no
way indicative of a fault with the audio
system.
Select "List" in the primary page.
Select "Radio list" in the secondary
page.
Or
Press 3 or 4 to move the cursor for an
automatic search down or up for a radio
frequency.
Or
283
.
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Select a radio station or frequency (refer to the
corresponding section).
Press on Radio Media to display the
primary page.
Press on the secondary page.
Select "Settings".
Select "Radio".
Activate/deactivate "RDS
options".
Press on Radio Media to display the
primary page.
Press on the secondary page.
Press on "Save" (preset).
Select a number in the list to preset the
previously chosen radio station.
A long press on a number saves (presets) the
station.
Press on Frequency.
Enter the frequency in full
(e.g.: 92.10 MHz) using the keypad
then "Confirm".
Changing radio station
Pressing the name of the current radio station
brings up a list.
To change radio station press the name of the
desired station.
Or
Press on Radio Media to display the
primary page.
Select "Save" (preset).
Presetting a station
Activating / Deactivating RDS
OR
THEN
A press on this button presets all of
the stations one after the other.
Recalling preset stations
RDS, if activated, allows you to continue
listening to the same station by automatic
retuning to alternative frequencies.
However, in certain conditions, coverage
of an RDS station may not be assured
throughout the entire country as radio
stations do not cover 100 % of the
territory. This explains the loss of
reception of the station during a journey.
284
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Display of options:
if active but not available, the display will be greyed out,
if active and available, the display will be blank.
Display of "Radiotext" for
the current station.
Manage the Jukebox.
Display current action.
Select the audio source.
Display the "DAB" band.
Display of the name of the
current station.
Short-cut: access to the choice of audio
source and the list of stations (or titles,
depending on the source).
Select the radio station.
Any thumbnail broadcast by
the station.
Preset stations,
buttons 1 to 15.
Short press: select the
preset radio station.
Long press: preset a radio
station.
Next "Multiplex".
Next radio station.
Secondary page.
Display the name and
number of the multiplex
service being used.
Previous "Multiplex".
Previous radio station.
DAB (Digital Audio Broadcasting) radio
If the "DAB" radio station being listened to is not
available on "FM", the "DAB FM" option is greyed out.
Journaline
®
is a text-based information service designed for digital radio systems.
It provides text-based information structured around topics and sub-topics.
This service is available from the "LIST OF DAB STATIONS" page.
285
.
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Select change of source.
Press on Radio Media to display the
primary page.
Select "DAB Radio".
Select "List" in the primary page.
Select the radio station from the list offered.
Press on Radio Media to display the
primary page.
Press on the secondary page.
Select "Settings".
Select "Radio".
Select "Digital/FM auto
tracking" then "Confirm".
DAB / FM auto tracking
Digital radio
"DAB" does not cover 100% of the
territory.
When the digital radio signal is poor,
"DAB/FM station tracking" allows you to
continue listening to the same station,
by automatically switching to the
corresponding "FM" analogue station
(if there is one).
If "DAB/FM station tracking" is
activated, there is a difference of a
few seconds when the system switches
to "FM" analogue radio with sometimes
a variation in volume.
When the digital signal is restored, the
system automatically changes back
to "DAB".
Digital radio provides higher quality
reception and also the graphical display
of current information on the radio
station being listened to. Select "List" in
the primary page.
The range of multiplexes available is
displayed in alphabetical order.
If the "DAB" station being listened to
is not available on "FM" ("DAB/FM"
option greyed out), or "DAB/FM station
tracking" is not activated, the sound
will cut out while the digital signal is too
weak.
or
Select "Radio list" in the secondary
page.
286
Audio and Telematics
2008_en_Chap12b_SMEGplus_ed01-2016
Media
USB player
Selecting the source
The steering mounted SRC (source)
button can be used to go to the next
media source, available if the source
is active.
Select change of source.
Press on Radio Media to display the
primary page.
The system builds playlists (in temporary
memory), an operation which can take from
a few seconds to several minutes at the first
connection.
Reduce the number of non-music files and the
number of folders to reduce the waiting time.
The playlists are updated every time the
ignition is switched off or connection of a USB
memory stick. The lists are memorised: if they
are not modified, the subsequent loading time
will be shorter.
Insert the USB memory stick into the USB port
or connect the USB device to the USB port
using a suitable cable (not supplied).
Auxiliary (AUX) socket
Connect the portable device (MP3 player…) to
the auxiliary Jack socket using an audio cable
(not supplied).
First adjust the volume of your portable device
(to a high level). Then adjust the volume of your
audio system.
Display and management of the controls are
via the portable device.
Choose the source.
CD player
Insert the CD in the player.
Press on OK to confirm the selection.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст