Citroen C3 Pluriel (2008 year). Instruction — part 7
1
2
IV
99
B O O T C O M PA R T M E N T C O V E R
D. To lock the boot compartment
cover: First close the tailgate 1
then the boot cover 2.
The tailgate opening control is
accessed via the mobile fl ap in the
boot compartment cover.
To remove the boot compartment
cover, proceed in reverse order.
Do not place any object on the boot compartment cover.
IV
100
S I D E C O V E R S
The side covers are to be found on
the interior face of the boot com-
partment cover.
Positioning the side covers:
Deploy the ring located beneath
the cover.
Make sure that the telescopic han-
dles are in the fully up position
when placing the side covers.
Place the cover in the location
vacated by the arch.
Lower the telescopic handle with
the palm of your hand to lock the
cover in position.
A
IV
101
A C O U S T I C C O M F O R T
Aero-acoustic defl ector
Your vehicle is equipped with an aero-acoustic mobile defl ector for sup-
pressing any air turbulence which may occur when driving in saloon confi gu-
ration with the roof open.
Operation
The defl ector deploys automatically when the roof is opened.
The latch A permits you to immobilise it.
Advice:
To improve your comfort when in cabriolet or spider confi guration, it is rec-
ommended:
to have the front and rear windows up
to immobilise the acoustic defl ector in the closed position.
In saloon confi guration with the roof closed for driving at high speed, you
are recommended to immobilise the aero-acoustic defl ector in the closed
position.
•
•
1
2
A
V
102
B O N N E T R E L E A S E
Bonnet release
This operation should only be
performed while the vehicle is
stationary.
To release the bonnet, pull the con-
trol located under the dashboard
towards you.
Bonnet stay: Unclip and swivel
the strut, to insert it in notch 1, then
in notch 2 (See arrow indication).
Warning: Do not pull the strut
towards the front.
To close
Fit the strut in its place.
Lower the bonnet carefully, then
let it drop shut. Avoid opening the
bonnet in high winds.
Action the control A situated below
the chevrons, then lift.
Note: The panel may be hot after
the vehicle has been in use.
Check that the bonnet is
properly secured.
A
B
103
L E V E L S
Air fi lter
Follow the requirements
set out in the Maintenance
Guide.
REFER TO THE CHAPTER: USER PRECAUTIONS.
Screen wash and head-
lamp wash fl uid
Use
CITROËN-approved
products wherever possible.
Capacity: See “Capacities”.
Engine coolant
The fl uid level should be
between the marks MIN. and
MAX. on the header tank.
Engine hot, wait at least 15 minutes.
Quality: See “Maintenance Guide”.
Never do anything relating to
the cooling system of an engine
that is hot.
12V battery
See “Starting with a slave
battery”.
Engine oil
Check the engine oil level
on horizontal ground with
the engine having been
switched off for at least 10 min-
utes.
Quality: See “Maintenance Guide”.
Pull out the manual dip-
stick.
The level should be between
the marks MIN. and MAX.
on the gauge.
It must never exceed the
maximum.
MAX.
MIN.
Brake fl uid
The level of fl uid should be
between the marks MIN.
and MAX. on the reservoir.
Quality: See “Maintenance Guide”.
If the warning lamp comes on
while you are driving, stop
immediately
and
contact
a
CITROËN dealer.
immediately
and
immediately
Cabin particle fi lter/
Odour fi lter
See “Maintenance Guide”.
If opening the bonnet when the engine is hot, even if it is
stopped and the ignition is switched off, remember that the
cooling fan may operate at any moment.
Consult “User Precautions” at the end of this handbook.
V
107
L E V E L S
Engine oil
Check the engine oil level on horizontal ground with the engine having been
switched off for at least 10 minutes.
Pull out the manual dipstick.
The level should be between the marks MIN. and MAX. on the gauge.
Topping up engine oil
Before fi lling, pull out the dipstick.
Check the dipstick after fi lling.
It must never exceed the maximum.
Screw the cap back on and close the bonnet.
Quality: See “Maintenance Guide”.
If opening the bonnet when the engine is hot, even if it is
stopped and the ignition is switched off, remember that the
cooling fan may operate at any moment.
V
108
Topping up the coolant
The fl uid level should be between the marks MIN. and MAX.
on the header tank.
Top up the level. If you have to put in more than 1 litre, have
the cooling system checked by a CITROËN dealer.
Top up the level. If you have to put in more than 1 litre,
more than
Make sure that the cap is back on properly.
Note:
If you need to top up the fl uid frequently, this indicates
a malfunction which you should get checked at the earliest
opportunity.
Quality: See “Maintenance Guide”.
Remark:
The cooling fan may operate for around 10 minutes after the
engine has stopped.
If opening the bonnet when the engine is hot, even if it is
stopped and the ignition is switched off, remember that the
cooling fan may operate at any moment.
L E V E L S
Radiator – coolant fl uid
Checking the level and topping up
with fl uid must always be done with
the engine cold.
Engine hot
Release the protection cover.
Wait 15 minutes or for the temper-
ature to be lower than 100°C and
then carefully unscrew the cap so
as to allow the pressure to drop,
protecting yourself with, say, a
cloth.
V
104
1 . 4 i E N G I N E
V
105
1 . 6 i 1 6 V E N G I N E
V
106
H D i
7 0 E N G I N E
The diesel fuel circuit being
under high pressure:
ANY INTERVENTION ON THE
CIRCUIT IS PROHIBITED.
HDi engines are the result of advanced technology.
Any intervention requires special qualifi cations
which only a CITROËN dealer can guarantee.
Any intervention requires special qualifi cations
Any intervention requires special qualifi cations
V
109
D I E S E L I N J E C T I O N E Q U I P M E N T
Priming the fuel system
Detach the protection cover to
access the priming pump.
HDi engines are the result of advanced technology.
Any intervention requires special qualifi cations which only a CITROËN
dealer can guarantee.
Draining water from the fuel
fi lter
Purge regularly (at each oil change).
To drain the water, slacken the
bleed screw or the water-in-diesel-
fuel sensor located at the base of
the fi lter.
Operate until the water has com-
pletely drained away.
Then retighten the bleed screw or
the water in diesel fuel sensor.
In the event of running out of fuel:
After fi lling (5 litres minimum),
operate the manual priming
pump until some resistance is
felt.
Operate the starter motor while
depressing
the
accelerator
pedal slightly until the engine
starts.
If the engine fails to start at the fi rst
attempt, wait 15 seconds before
trying again.
If the engine fails to start after sev-
eral attempts, repeat the procedure
from the beginning.
When the engine is idling, acceler-
ate slightly to complete the bleed-
ing of the circuit.
•
•
V
110
C A P A C I T I E S
Engine type
Engine oil capacities (in litres)
(1)
1.4i engine
3.2
1.6i 16V engine
3.2
HDi 70 engine
3.8
(1)
Drain, refi ll and replace oil fi lter.
Screen wash fl uid (in litres)
3.5
V
111
F U S E S
Fuseboxes
There are two fuse boxes, one below the dashboard and one under the
bonnet.
Dashboard fuses
The fuse box is located in the lower glovebox compartment.
To access the fuses, open the glove box, pull the handle on the fuse box
cover.
Replacing a fuse
Before replacing a fuse, you should ascertain the cause of the fault and
have it remedied. The numbers of the fuses are indicated on the fusebox.
Replace the fuse that has blown with one of the same rating (same
colour).
Use the special pliers A stowed on the cover close to the fuseboxes, this
includes a compartment for replacement fuses.
Good
Bad
Pliers A
V
112
T A B L E O F F U S E S
D A S H B O A R D F U S E S
Ref.
Rating
Function
3
5 A
Airbags
4
10 A
Diagnostic socket – Clutch switch – Steering angle sensor
5
30 A
Rear window – Sun roof
6
30 A
Screen wash
8
20 A
Digital clock – Controls at the steering wheel – Radio – Display
9
30 A
Cigar-lighter – Digital clock – Interior lamps – Vanity mirror
10
15 A
Alarm
11
15 A
Ignition switch – Diagnostic socket
12
15 A
Airbag ECU – Rain and brightness sensor
14
15 A
Parking assistance – Instrument panel – Air conditioning – Bluetooth
®
telephone
®
15
30 A
Central locking – Deadlocking
17
40 A
Heated rear screen
18
SHUNT
CUSTOMER PARK SHUNT
V
113
F U S E S
Any action on the MAXI fuses (that give extra protection) (in
grey in the diagrams), located in the fuseboxes, should be left
to a CITROËN dealer.
grey in the diagrams), l
the dia
Fuses under the bonnet
Fusebox
To access the fusebox located in
the engine compartment, remove
the battery cover and detach the
lid.
After a repair, take care to
reclose the cover.
V
114
T A B L E O F F U S E S
F U S E S U N D E R T H E B O N N E T
Ref.
Rating
Function
1
20 A
Water-in-diesel-fuel sensor
2
15 A
Horn
3
10 A
Screen wash
4
20 A
Headlamp wash
5
15 A
Fuel pump
6
10 A
Power steering
7
10 A
Coolant level sensor
8
25 A
Starter
9
10 A
ECUs (ABS, ESP)
10
30 A
Engine control actuators (Ignition coil, Electrovalve, Oxygen sensor, Injection) – Canister purge
11
40 A
Air blower
12
30 A
Windscreen wiper
14
30 A
Air pump (petrol version) – Diesel fuel heater
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст