Renault Scenic 3 Chassis. Manual — part 26
36B
-
9
POWER ASSISTED STEERING
Steering column
36B
Remove the automatic parking brake catch moun-
ting bolts (13).
Disconnect the automatic parking brake control con-
nector.
Remove the catch.
Unclip the left footwell trim.
Unclip the front left-hand side panel.
AUTOMATIC PARKING BRAKE
103847
103850
13
103848
36B
-
10
POWER ASSISTED STEERING
Steering column
36B
Remove:
- the bolts,
- the lower section of the dashboard,
Remove the air duct.
Unclip the instrument panel upper trim.
103849
103853
104102
103585
36B
-
11
POWER ASSISTED STEERING
Steering column
36B
Unclip the instrument panel lower trim.
Pull back the carpet on the driver's side.
Remove the cover (5) using a hammer. Do not keep
it.
Remove the steering column universal joint bolt.
Remove the column lock bolt (6).
Disconnect the column lock connector.
Remove the column lock.
Disconnect:
- the electric power assisted steering computer
power connector using a screwdriver 4 mm wide
and 0.5 mm thick,
- the electric power assisted steering computer si-
gnal connector using a screwdriver 4 mm wide and
0.5 mm thick.
Unclip the steering column rotary switch wiring har-
ness (7).
103584
101354
5
104016
Note:
- The column lock is mounted by a left-hand
thread bolt.
WARNING
Do not unclip the clip from the column, this could
break it.
6
7
36B
-
12
POWER ASSISTED STEERING
Steering column
36B
Remove the steering column upper mounting nut (8).
Remove:
- the three steering column mounting lower nuts,
- the steering column.
REFITTING
Proceed in the reverse order to removal.
Refit the steering column, starting with the furthest
lower threaded stud, and finishing with the upper
threaded stud.
104019
104018
8
WARNING
Push and pull on the electric power assisted
steering computer power and signal connectors
to check that they are properly secured (risk of
loss of assistance).
- The steering wheel should enter the splines
freely (the splines are foolproofed).
- Do not damage the foolproofing splines.
- Be sure to replace the steering wheel bolt each
time it is removed.
Note:
- Be sure to replace the steering column universal
joint bolt and eccentric nut each time they are
removed.
- Do not refit the cover (14).
- On a new steering column, the universal joint
eccentric nut is pre-fitted.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст