Dacia Pick-Up 1304/1305/1307. Manual — part 94
37
MECHANICAL ELEMENTS CONTROLS
HANDBRAKE PRIMARY AND SECONDARY CABLE
THE HAND BRAKE SECONDARY CABLE REPLACEMENT
D
ISMO UNTING
Dismount the hand brake lever.
Disconnect the primary cable from the
rocking joint.
Dismount the stop sheath of the primary
cable.
R
EMO UNTING
Place a sealant material layer between the floor and the primary cable case.
Mount the primary cable.
Mount the stop sheath.
Mount the hand brake lever.
Adjust the hand brake.
37 - 11
MECHANICAL ELEMENTS CONTROLS
37
HAND BRAKE SECONDARY CABLE REPLACEMENT
D
ISMO UNTING
Disconnect the battery.
Release the primary cable from the rocking joint.
Dismount the drums.
Lift the motor-car by means of a jack.
Unscrew the nuts M and N.
Release the secondary cable from the control levers.
Dismount the sheathes stops (from the plate and from the floor).
Dismount the secondary cable.
R
EMO UNTING
Position the secondary cable.
Connect the secondary cable in:
-
the floor;
-
the sheaths stops from the plate;
-
the sheaths stops floor.
Adjust the hand brake.
Tighten to the required moment the nut N.
HANDBRAKE PRIMARY AND SECONDARY CABLE
37 - 12
M
N
37
MECHANICAL ELEMENTS CONTROLS
BRAKE LIMITER CHECKING-ADJUSTMENT
Place the vehicle on the checking bench so that wheels are in contact with the ground
(unloaded pick up and one person on board ).
Mount in the place of the purging screw of the brake cylinder, the FR 214 – 02 checking
manometer.
Dismount the fork from the big spring.
After 3,4 successively pressings, the brake pedal remains pressed.
Read the value of the pressure which must be 20 bars.
In order to obtain this value, strain by bending the limiter support slide from the base
( Z area) for lower the pressure ( to inner side ).
BRAKE LIMITER
+0
-2
37 - 13
MECHANICAL ELEMENTS CONTROLS
37
BRAKE LIMITER
After obtaining the pressure of 20
bars, with the brake pedal pressed, slide the
passing fork (3) until the contact with the limiter control lever.
In this moment block the passing fork by means of the screw (1) and the nut (2).
Release the brake pedal and purge the braking circuit.
Dismount the manometer and the adjustment is considered ready.
OBSERVATION!
If, with the limiter being mounted, the pressure of 20 bars can not be obtained,
proceed to the limiter replacement.
Repairing of the limiter is forbidden !
+ 0
- 2
+ 0
- 2
37 - 14
O
1
O
2
O
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст