Renault Magnum engine. Manual — part 14
4 / 25
Immobilize liners
(15).
Use tool 1462.
Crankshaft
Clean the contact faces thoroughly.
Fit bearing half-shells
(22).
Match the direction of orientation.
Line up the lubrication holes.
Apply oil (engine oil) to the inner faces of bearing half-shells
(22) when installing them. Do not apply oil to the support face.
5 / 25
Apply oil to the crankpins.
Fit crankshaft
(25).
Use tool 9804.
Use lifting tackle.
6 / 25
Clean the contact faces thoroughly.
Fit bearing half-shells
(21).
Match the direction of orientation.
Apply oil (engine oil) to the inner faces of bearing half-shells
(21) when installing them. Do not apply oil to the support face.
Lubricate thrust half-rings
(24).
Use engine oil.
Install thrust half-rings
(24).
Match the direction of orientation.
Check for the presence of dowel
(26).
Lubricate thrust half-rings
(23).
Use engine oil.
Position thrust half-rings
(23) on bearing cap (27).
Match the direction of orientation.
Fit bearing cap
(27) complete with thrust half-rings (23).
Check that dowel
(26) is properly engaged in its housing.
7 / 25
Fit bearing caps
(20).
The numbers marked on the bearing caps must be positioned at the oil cooler casing end.
The bearing caps are marked from
1 to 7, N° 1 bearing at the engine front end.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст