Renault Magnum engine. Manual — part 4
3 / 9
Fit ring gear.
Fitting
Clean the contact faces thoroughly.
To fit, proceed in the reverse sequence to removal.
4 / 9
Retain the flywheel against motion using tool 1380.
Tighten bolts
(1) to torque following the tightening sequence.
See pages .
Use tool 9776.
5 / 9
Fit engine speed sensor
(2).
Tighten to torque.
See pages .
Check the air gap.
See pages .
Plug in connector
(1).
Fit pilot bearing
(1).
Make pilot bearing
(1) flush with its housing.
Use tool 2363 + 3016.
6 / 9
Inspection of the flywheel run-out
Check the buckle.
Use tool 3241 + 9661.
Note down the value.
If the measured value is higher than the Manufacturer's value, see page(s) .
Remove the engine flywheel.
Clean the contact faces thoroughly.
Tools
General purpose tools
Illustration
RENAULT
TRUCKS part N°
Designation
Manufacturer's
reference N°
Manufacturer's code N°
Scale
Qty
9675
THERMOMETER
AL
APPA 51 + 80110
1
1
9661
MEASURING TOOL
(DIAL GAUGE AND
MAGNETIC FOOT)
AQ
2
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст