Daewoo Nubira. Manual — part 192

9E – 34

I

INSTRUMENT/DRIVER INFORMATION

DAEWOO V–121 BL4

Installation Procedure

1. Install the fuel gauge to the cluster assembly with

the fuel gauge screws.

Tighten

Tighten the fuel gauge screws to 2.5 N

S

m (22 lb–in).

2. Install the instrument cluster lens.
3. Install the instrument cluster. Refer to ”Instrument

Cluster” in this section.

4. Connect the negative battery cable.

TEMPERATURE GAUGE

Removal Procedure

1. Disconnect the negative battery cable.
2. Remove the instrument cluster. Refer to ”Instru-

ment Cluster” in this section.

3. Remove the instrument cluster lens screws and the

instrument cluster lens.

INSTRUMENT/DRIVER INFORMATION 9E – 35

DAEWOO V–121 BL4

4. Remove the temperature gauge screws and the

temperature gauge from the cluster assembly.

Installation Procedure

1. Install the temperature gauge to the cluster assem-

bly with the temperature gauge screws.

Tighten

Tighten the temperature gauge screws to 2.5 N

S

m (22

lb–in).

2. Install the instrument cluster lens.
3. Install the instrument cluster. Refer to ”Instrument

Cluster” in this section.

4. Connect the negative battery cable.

9E – 36

I

INSTRUMENT/DRIVER INFORMATION

DAEWOO V–121 BL4

INSTRUMENT CLUSTER INDICATOR
LAMPS

Removal Procedure

1. Disconnect the negative battery cable.
2. Remove the instrument cluster. Refer to ”Instru-

ment Cluster” in this section.

3. Remove the bulb from the rear of the cluster.

Installation Procedure

1. Install the new bulb.
2. Install the instrument cluster. Refer to ”Instrument

Cluster” in this section

3. Connect the negative battery cable.

CHIME MODULE

Removal Procedure

1. Disconnect the negative battery cable.
2. Remove the knee bolster trim panel beneath the

steering column.

3. Disconnect the electrical connector.
4. Remove the screws and the chime module.

INSTRUMENT/DRIVER INFORMATION 9E – 37

DAEWOO V–121 BL4

Installation Procedure

1. Install the chime module with the screws.

Tighten

Tighten the chime module screws to 4 N

S

m (35 lb–in).

2. Connect the electrical connector.
3. Install the knee bolster trim panel beneath the

steering column.

4. Connect the negative battery cable.

INSTRUMENT PANEL

Removal Procedure

1. Disconnect the negative battery cable.
2. Remove the floor console. Refer to Section 9G,

Interior Trim.

3. Remove the audio system. Refer to Section 9F,

Audio Systems.

4. Remove the HVAC controls. Refer toSection 7A,

Heating and Ventilation System.

5. Remove the instrument cluster. Refer to ”Instru-

ment Cluster” in this section.

6. Remove the A–pillar trim panels. Refer toSection

9G, Interior Trim.

7. Install the driver and passenger knee bolsters. Re-

fer toSection 9G, Interior Trim.

8. Disconnect the sun sensor electrical connector.
9. Remove the nuts and the bolts that secure the

steering column.

10. Lower the steering column.
11. Remove the screw that secures the instrument pan-

el to the heater air distributor case.