Daewoo Korando. Manual — part 198
OM600 ENGINE INTAKE & EXHAUST 1G3-3
Removal & Installation Procedure
1. Loosen the air duct hose clamp and then remove the air
cleaner and air duct hose.
2. Disconnect the air cleaner housing cover clamp and remove
the cover and element.
Tightening Torque
9 - 11 Nm
3. Loosen the nut (4EA) and remove the air cleaner housing
from the intake manifold.
Notice
Do not fold the rubber.
Operating Interval
Clean
Replace
every 20,000km
every 60,000km
4. Loosen the clamp and remove the air duct hose.
5. Loosen the mounting nut and bolt.
6. Remove the air inlet duct and hose.
7. Installation should follow the removal procedure in the
reverse order.
1G3-4 OM600 ENGINE INTAKE & EXHAUST
INTAKE AND EXHAUST MANIFOLD
1 Nut . . . . . . . . . . . . . 22.5-27.5 Nm
2 Washer
3 Support Assembly Bar
4 Nut . . . . . . . . . . . . . 22.5-27.5 Nm
5 Exhaust Manifold Assembly
6 Exhaust Gasket
7 Stud Bolt . . . . . . . . . . .. 9.9-12.1 Nm
8 Bolt (M8) . . . . . . . . . . 22.5-27.5 Nm
9 Intake Duct
10 Intake Duct Gasket
11 Intake Manifold
12 Intake Gasket
OM600 ENGINE INTAKE & EXHAUST 1G3-5
Exhaust Line
1 Heat Protector Assembly
2 Heat Protector Floor
3 Exhaust Front Pipe Assembly
4 Ring
5 Exhaust Rear Pipe Assembly
6 Muffler
7 Mounting
8 Heat Protector Front Floor
9 Tail Exhaust Pipe Assembly
1G3-6 OM600 ENGINE INTAKE & EXHAUST
Removal & Installation Procedure
1. Remove the bolt from the exhaust manifold and then remove
the front exhaust pipe.
Installation Notice
Tightening Torque
15 - 18 Nm
Notice
When tightening the nut(3), maintain the clearance between
exhaust manifold(1) and front exhaust pipe.
2. Remove the nut from the front of center muffler and then
remove the front exhaust pipe.
Installation Notice
3. Remove the nut from the rear of center muffler and then
remove the tail muffler.
Installation Notice
4. Remove the muffler mounting hanger from the rubber pad
and remove the center muffler and tail muffler.
Notice
Check the gasket, if necessary, replace the new one.
5. Installation should follow the removal procedure in the
reverse order.
Tightening Torque
28 - 47 Nm
Tightening Torque
28 - 47 Nm
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст