Daewoo Musso. Manual — part 213

2D-10 REAR SUSPENSION

Removal & Installation Procedure

1. Disconnect actuator connector and unscrew bolt and remove

actuator assembly.

Notice

l

When installing the actuator to the mounting bracket,

the wiring should face outward of the frame.

l

Actuator wiring should be fixed 40 - 50mm away from

the wiring ends when fixing it with the frame open clip.

2. Unscrew the upper nut (6).

Notice

When screwing the nut, actuator contacting surface of the
mounting bracket and rod end should be 0.5 - 1.5mm.

3. Remove the mounting bracket (5).

Notice

When installing the bracket, it should be parallel to the frame
side member.

4. Remove the bush and check for damage and replace if

necessary.

5. Unscrew shock absorber lower bolt and nut and remove

the shock absorber.

Notice

Shock absorber is filled with gas, never attempt to cut or
heat.

6. Installation should follow the removal procedure in the

reverse order.

Description

Alumimun

7JJ X 15

Radial Tire

P215 / 75R 15 - 30psi

P235 / 75R 15 - 30psi

P255 / 70R 15 - 30psi

Application

Wheel

SECTION 2E

TIRES AND WHEELS

TABLE OF CONTENTS

SPECIFICATIONS

GENERAL SPECIFICATIONS

FASTENER TIGHTENING SPECIFICATIONS

Application

Wheel Bolt

N

l

m

80 - 120

110 - 130

Specifications . . . . . . . . . . . . . . . . . . . . . . . . 2E-1

General Specifications . . . . . . . . . . . . . . . . . . 2E-1

Fastener Tightening Specifications . . . . . . . . . 2E-1

Diagnosis . . . . . . . . . . . . . . . . . . . . . . . . . . . 2E-2

Wear Pattern Diagnosis . . . . . . . . . . . . . . . . . 2E-2

Identification . . . . . . . . . . . . . . . . . . . . . . . . . 2E-3

Radial Tire . . . . . . . . . . . . . . . . . . . . . . . . . . . 2E-3

Wheel Disc . . . . . . . . . . . . . . . . . . . . . . . . . . . 2E-3

Component Locator . . . . . . . . . . . . . . . . . . . 2E-4

Wheel and Tire . . . . . . . . . . . . . . . . . . . . . . . . 2E-4

Maintenance and Repair . . . . . . . . . . . . . . . 2E-5

On-Vehicle Service . . . . . . . . . . . . . . . . . . . . . 2E-5

Wheels and Tires . . . . . . . . . . . . . . . . . . . . . . 2E-5

Material

Size

Tire

Type

Size and Tire Pressure

Steel

Alumimum

2E-2 TIRES AND WHEELS

DIAGNOSIS

WEAR PATTERN DIAGNOSIS

Wear Pattern

Possible Cause

Remedy

Wear on Both Tread Shoulders

Under Inflation

Wear on Tread Center

Over Inflation

Tread Torn Out

Under Inflation

One-sided Tread Wear

Incorrect Camber or Toe-in

Feather Edging of Tread

Incorrect Toe-in

Spotty Tread Wear

Out of Wheel Balance

Spotty Wear-wear Localized on
Shoulder Sections

Out of Wheel Balance

Play in Hub Bearings

Play in Ball Joint

Defective Shock Absorber

Adjust

Adjust

Adjust

Adjust

Adjust

Adjust

Adjust

Check play

Adjust preload

Check

Check

TIRES AND WHEELS 2E-3

IDENTIFICATION

RADIAL TIRE

WHEEL DISC

7 J x 16 ET 39

Wheel Offset (mm)

(Distance from rim center to wheel
nave contacting surface)

Rim Diameter (inch)

Identification for One-piece Well-base Rim

Code Letter for Height and Profile of Rim Flange

Rim Width (Inch)

ET :

Distance from Rim Center to Wheel have Contacting

Surface (mm)

a :

Rim Width (Inch)

d :

Rim Diameter (Inch)

Four Season Mud & Snow

P 215/75 R 15 94 H M+S

Speed Rating (max. 210km/h)

Load Range (below 670kg)

Rim Diameter (inch)

Radial Tire

Aspect Ratio = (Section Height

¸

Section

Width) x 100

Section Width (mm)

Passenger Car

215/65 R 16 93 V

Speed Rating (max. 240km/h)

Load Range (below 650kg)

Rim Diameter (inch)

Radial Tire

Aspect Ratio = (Section Height

¸

Section

Width) x 100

Section Width(mm)

Summer Tire