Hyundai Santa Fe (2006 year). Manual — part 188
LIGHTING SYSTEM
BE -213
TURN SIGNAL LAMP
REPLACEMENT
EEF3E5C7
1.
Disconnect the negative (-) battery terminal.
2.
Loose the screws (3EA) holding the rear combination
lamp then disconnect the 4P connector then remove
the outside rear combination lamp.
SCMBE6448D
SCMBE6449D
3.
Replace the bulbs (2EA) after disconnecting the rear
combination lamp assembly..
SCMBE6450D
4.
Disconnect the lamp cover on tailgate. Remove the
lamp assembly after loosening the connector (4pin),
Cap nuts (2EA) and nuts (2EA).
5.
Remove the tailgate combination lamp assembly and
the replace the bulbs.
SCMBE6451D
6.
Installation is the reverse of removal.
BE -214
BODY ELECTRICAL SYSTEM
ROOM LAMP
INSPECTION
EA676E05
1.
Remove the room lamp assembly then check for con-
tinuity between terminals.
1
2
3
SCMBE6453L
1
2
3
ON
DOOR
OFF
Terminal
Position
SCMBE6454L
REPLACEMENT
E342AAEF
1.
Disconnect the negative (-) battery terminal.
2.
Detach the lamp lens (A) from the room lamp with a
flat-tip screwdriver then replace the bulb.
3.
Loosen the fixing screw (2EA) and disconnect the 3P
connector. And then remove the room lamp assembly.
A
SCMBE6452D
4.
Installation is the reverse of removal.
LIGHTING SYSTEM
BE -215
OVERHEAD CONSOLE LAMP
INSPECTION
E0EDDEFD
Remove the overhead console lamp assembly then check
for continuity between terminals. If the continuity is not as
specified, replace the map lamp switch.
1
2
SCMBE6457D
1
LH
RH
ON
OFF
ON
OFF
2
Sort
Map lamp switch
Position
Terminal
ETKE007M
REPLACEMENT
E0EB8DD4
1.
Disconnect the negative (-) battery terminal.
2.
Replace the bulb after removing the lens.
3.
Remove the 2 screws, sunroof switch connectors
(4Pin / 2Pin). And then remove the overhead consol
(A), lamp (B).
A
SCMBE6455D
B
SCMBE6456D
4.
Installation is the reverse of removal.
BE -216
BODY ELECTRICAL SYSTEM
TURN / HAZARD LAMPS
INSPECTION
EBC7E7BC
HAZARD LAMP SWITCH
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad center speaker grill (A).
A
SCMBE6460D
3.
Remove the center speaker (A) after loosening the
screws (2EA).
A
SCMBE6015D
4.
Remove the center facia panel after loosning the
screw (2EA).
(Refer to the Body group - Crash pad)
: Screw, 2
A
SCMBE6010L
5.
Disconnect the conectors.
6.
Operate the switch and check for continuity between
terminals with an ohmmeter.
[LHD]
REA
R
REAR
A/C
FRO
NT
SCMBE6467D
[RHD]
REA
R
REAR
A/C
FRO
NT
SCMBE6467R
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст