Hyundai Santa Fe (2006 year). Manual — part 145
KEYLESS ENTRY AND BURGLAR ALARM
BE -41
DESCRIPTION
E5FCECF8
BURGLAR ALARM SYSTEM
The burglar alarm system is armed automatically after the
doors, hood, and tailgate are closed and locked.
The system is set off when any of these things occur :
• A door is forced open.
• The tailgate is opened without using the key.
• The hood is opened.
When the system is set off, the alarm sounds and the haz-
ard lamp flash for about 30 seconds or until the system is
disarmed by unlocking the transmitter.
For the system to arm, the ignition switch must be off and
the key removed. Then, the body control module must re-
ceive signals that the doors, hood, and tailgate are closed
and locked. When everything is closed and locked, none
of the control unit inputs are grounded.
The door switches, hood switch and tailgate switch are all
close and lock the doors with the remote transmitter and
then the system arms immediately.
If anything is opened after the system is armed, the body
control module gets a ground signal from that switch, and
the system is set off.
If one of the switches is misadjusted or there is a short in
the system, the system will not arm. As long as the body
control module continues to get a ground signal, it thinks
the vehicle is not closed and locked and will not arm.
KEYLESS ENTRY SYSTEM
The burglar alarm system is integrated with the keyless
entry system. The keyless entry system allows you to lock
and unlock the vehicle with the remote transmitter. When
you push the LOCK/UNLOCK button, all doors lock. When
you push the LOCK/UNLOCK button again, all doors un-
lock.
The room lamp, if its switch is in the center position, will
come on when you press the UNLOCK button. If you do
not open a door, the light will go off in about 30 seconds,
the doors will automatically relock, and the burglar alarm
system will rearm. If you relock the doors with the remote
transmitter within 30 seconds, the light will go off immedi-
ately.
You cannot lock or unlock the doors with the remote trans-
mitter if the key is in the ignition switch.
The system will signal you when the doors lock and un-
lock by flashing the hazard lamp once when they lock, and
twice when they unlock.
BE -42
BODY ELECTRICAL SYSTEM
FUNCTION
E3F8A938
ANTI-THEFT WARNING SYSTEM
* Arm Mode
All Doors :
Transmitter
Lock Signal
Close
* Auto Lock Timer 1
All Doors : Close
or Arm Mode
Transmitter
Unlock Signal
Auto Lock
Timer 1
Arm Wait
(30 sec)
Arm Wait
(30 sec)
Arm Wait
(30 sec)
Door Open or Door Unlock
Disarm Mode
Arm Mode
* Auto Lock Timer 2
All Doors : Close
Hood : Open
Transmitter
Lock Signal
Auto Lock
Timer 2
Hood :
Open
Hood :
Close
Pre arm
Pre arm
Arm Mode
Arm Mode
* Auto Lock Timer 2
Arm Mode
Door Open
Door Open
Auto Lock
Timer 1
Alarm
Tx
Unlock
Signal
Tx
Lock
Signal
Rearm
(or Arm Mode)
Disarm
Mode
Arm Mode
Tx : Transmitter
SCMBE6089L
KEYLESS ENTRY AND BURGLAR ALARM
BE -43
1.
SECURITY LED CONTROL
1)
If the KEY IN is ON or ACC is ON or IGN1 is ON
or IGN2 is ON, the LED shall be OFF.
2)
When entered into the ARM WAIT mode in the
IGN KEY OUT state, control not only the FULL
ON but also the BLINKING in the mode other
than the ARM WAIT.
3)
The BLINKING cycle is 2.3 seconds, and it is ON
for 0.3 seconds and OFF for 2.0 seconds.
SECURITY
LED
ON
B/ALARM
STATE
ARM WAIT
The other
OFF
T2
T1
SCMBE6123L
T1 : 0.3s, T2 : 2s
BE -44
BODY ELECTRICAL SYSTEM
2.
DISARM
CONDITION 1
State
Description
Initial Condition
ALARM
Transition Condition
-
When 4DOOR or T/GATE is OPEN and TX(Transmitter) UNLOCK is input
-
After 30 seconds in the KEY IN ON and IGN1 ON and IGN2 ON states
-
When all doors are unlocked (LOCK FAIL) within 5 seconds after
the TX(Transmitter) LOCK input
Operating
-
ENTRY INTO THE DISARM STATE
-
HORN, HAZARD, B/ALARM output shall be OFF
-
In the case of the TX UNLOCK input, the HAZARD LAMP signal is output
with the cycle of the ON/OFF of 0.5 seconds two times.
CONDITION 2
State
Description
Initial Condition
In the DISARM state and any one of the IGN KEY OUT & 4DOOR and T/GATE are opened
Transition Condition
When entering TX UNLOCK
Operating
-
Maintain in the DISARM state
-
The HAZARD LAMP signal is output with the ON/OFF cycle of 0.5 seconds two times.
CONDITION 3
State
Description
Initial Condition
ARM WAIT state
Transition Condition
-
When any one of the 4DOOR, HOOD or T/GATE is opened.
-
When at least one or more doors are unlocked.
-
In case of KEY IN.
-
When the DRIVER KEY UNLOCK(T/GATE KEY UNLOCK) signal is input
Operating
-
ENTRY INTO THE DISARM STATE
CONDITION 4
State
Description
Initial Condition
AUTOLOCK TIMER1 state
Transition Condition
-
When any one of the 4DOOR, HOOD or T/GATE is opened.
-
In case of KEY IN.
-
LOCK FAIL after the LOCK attempt by the AUTO LOCK.
-
LOCK FAIL after the LOCK attempt by the TX LOCK.
-
LOCK FAIL after the LOCK attempt by the DRIVER KEY LOCK(T/GATE KEY LOCK).
Operating
-
ENTRY INTO THE DISARM STATE
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст