Hyundai Santa Fe (2006 year). Manual — part 265
DS -20
DRIVESHAFT AND AXLE
12. Install the wheel and tire (A) to the front hub (B).
Tightening torque Nm (kgf-m, lb-ft) :
88.3~107.9 (9~11, 65.1~79.6)
B
C
A
SCMDS6003D
CAUTION
Be careful not to damage the hub bolts (C) when
installing the front wheel and tire (A).
DRIVESHAFT
DS -21
FRONT DRIVESHAFT
(PTJ-BJ TYPE)
COMPONENT
E91015BA
[LH]
11
11
12
13
15
14
14
10
8
9
1
2
3
4
5
7
6
6
1. Split pin
2. Castle nut
3. Washer
4. BJ assembly
5. Clip A
11. PTJ boot band
12. PTJ boot
13. Trunion assembly
14. Circlip
15. PTJ assembly
6. BJ boot band
7. BJ boot
8. Dynamic damper band
9. Dynamic damper
10. Shaft
SCMDS6503L
DS -22
DRIVESHAFT AND AXLE
[RH]
1. Split pin
2. Castle nut
3. Washer
4. BJ assembly
5. Clip A
11. PTJ boot band
12. PTJ boot
13. Trunion assembly
14. Circlip
15. PTJ assembly
1
2
3
4
5
6
6
7
9
8
11
10
12
11
13
14
15
6. BJ boot band
7. BJ boot
8. Dynamic damper band
9. Dynamic damper
10. Shaft
SCMDS6504L
DRIVESHAFT
DS -23
DISASSEMBLY
E7560CE9
CAUTION
•
Do not disassemble the BJ assembly.
•
Special grease must be applied to the drive-
shaft joint.
Do not substitute with another
type of grease.
•
The boot band should be replaced with a new
one.
1.
Remove the circlip (B) from driveshaft splines (A) of
the transaxle side PTJ case.
A
B
KXDDE07A
2.
Remove the both boot clamps from the transaxle side
PTJ case.
1)
Using a flat-tipped (-) screwdriver, remove the
both clamps of the transaxle side.
SCMDS6515D
3.
Pull out the boot from the transaxle side joint(PTJ).
4.
Remove the clip (C) from the PTJ case (B).
5.
While dividing joint(PTJ) boot (A) of the transaxle side,
wipe the grease in PTJ case (B) and collect them re-
spectively.
B
A
C
SCMDS6505D
CAUTION
•
Be careful not to damage the boot.
•
According to below the illustrated, put marks
(D) on roller of trunion assembly (A), PTJ case
(B) and spline part (C), for providing assem-
bly.
A
B
C
D
KXDDE11A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст