Hyundai Santa Fe (2006 year). Manual — part 69
ATA -34
AUTOMATIC TRANSAXLE (A5HF1)
POWER SUPPLY CIRCUIT INSPECTION
E8EED173
1.
CHECK POWER TO RANGE SWITCH
1)
Disconnect "TRANSAXLE RANGE SWITCH" connector.
2)
Ignition "ON" & Engine "OFF".
3)
Measure voltage between terminal "8" of the sensor harness connector and chassis ground.
Specification : approx. B+
C208
1
3
4
* *
*
7
8
9
10
1. D Range
3. P Range
4. N Range
7. R Range
8. Power supply IG1
9. Starting circuit
10. Starting circuit
SCMAT6301L
4)
Is voltage within specifications?
YES
▶ Go to "Signal circuit inspection" procedure.
NO
▶ Check that Fuse 10A is installed or not blown.
▶ Check for open in harness. Repair as necessary and go to "Verification of vehicle repair" procedure.
AUTOMATIC TRANSAXLE SYSTEM
ATA -35
SIGNAL CIRCUIT INSPECTION
E7739DDB
1.
Ignition "OFF".
2.
Disconnect "TRANSAXLE RANGE SWITCH" and "TCM(PCM)" connector.
3.
Measure resistance between each terminal of the sensor harness connector and TCM(PCM) harness connector as
below.
Specification :
Pin No of "TRANSAXLE RANGE
SWITCH"
C208 No.1
C208 No.3
C208 No.4
C208 No.7
Pin No of "TCM(PCM)" harness
C224-C No.17
C224-C No.5
C224-C No.6
C224-C No.16
Specification
0Ω
0Ω
0Ω
0Ω
5. R Range
6. N Range
16. D Range
1
3 2
4
5
6
7
9
8
10
22
21
-
-
18 17 16
-
-
13
12
1
3
4
5
6
7
8
9
-
-
-
3. P Range
4. N Range
7. R Range
8. Power supply IG1
9. Starting circuit
10. Starting circuit
Ω
C208
C224-C
SCMAT6302L
4.
Is resistance within specifications?
YES
▶ Go to "Component inspection" procedure.
NO
▶ Check for Open in harness. Repair as necessary and Go to "Verification of Vehicle Repair" procedure.
COMPONENT INSPECTION
EDE50D35
1.
Ignition "OFF".
2.
Remove "TRANSAXLE RANGE SWITCH".
3.
Measure the resistance between each terminal of the sensor.
Specification : approx. 0 Ω
ATA -36
AUTOMATIC TRANSAXLE (A5HF1)
1
*
7
8
9
10
1. D Range
3. P Range
4. N Range
7. R Range
8. Power supply IG1
9. Starting circuit
10. Starting circuit
Ω
3 4
* *
C208
[ RANGE SWITCH continuity check table (Case of SPORTS MODE vehicle has no 3,2,L range) ]
Range
P
R
N
D
Terminal
3
2
L
1
2
3
4
5
6
7
8
9
10
Component side
SCMAT6303L
4.
Is resistance within specifications?
YES
▶ Substitute with a known-good PCM/TCM and check for proper operation. If the problem is corrected, replace
PCM/TCM as necessary and then go to "Verification of Vehicle Repair" procedure.
NO
▶ Replace "TRANSAXLE RANGE SWITCH" as necessary and Go to "Verification of Vehicle Repair" procedure.
VERIFICATION OF VEHICLE REPAIR
EFEEFADF
After a repair, it is essential to verify that the fault has been corrected.
1.
Connect scantool and select "Diagnostic Trouble Codes(DTCs)" mode.
2.
Using a scantool, Clear DTC.
3.
Operate the vehicle within DTC Enable conditions in General information.
4.
Are any DTCs present?
YES
▶ Go to the applicable troubleshooting procedure.
NO
▶ System performing to specification at this time.
AUTOMATIC TRANSAXLE SYSTEM
ATA -37
DTC P0708 TRANSAXLE RANGE SWITCH - HIGH INPUT
COMPONENT LOCATION
EC58535A
Refer to DTC P0707.
GENERAL DESCRIPTION
E3DEE0BD
Refer to DTC P0707.
DTC DESCRIPTION
EFF1CACD
The TCM sets this code when the Transaxle Range Switch outputs multiple signals for more than 30 seconds.
DTC DETECTING CONDITION
EDECC03F
Item
Detecting Condition
Possible cause
DTC Strategy
• Check for multiple signals
Enable Conditions
• IG "ON"
• Not FailSafe Status
Threshold value
• Multiple signal
Diagnostic Time
• More than 30sec
Fail Safe
• Recognition as previous signal
-
When P-D or R-D or D-R SHIFT is detected,
it is regarded as N-D or N-R though "N"
signal is not detected
-
When sports mode S/W is ON without
P,R,N, D-RANGE signals, it is regarded
sports mode.(DTC is not set)
• Faulty Shift cable adjustment
• Faulty Inhibitor switch and
Manual control lever position
adjustment
• Open or short in circuit
• Faulty TRANSAXLE RANGE
SWITCH
• Faulty TCM(PCM)
SIGNAL WAVEFORM
E887562F
Refer to DTC P0707.
MONITOR SCANTOOL DATA
E8B2B8B7
Refer to DTC P0707.
TERMINAL & CONNECTOR INSPECTION
E548DF70
Refer to DTC P0707.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст