Hyundai Santa Fe (2006 year). Manual — part 163
FUSES AND RELAYS
BE -113
INSPECTION
ED3ADA2E
FUSE
1.
Be sure there is no play in the fuse holders, and that
the fuses are held securely.
2.
Are the fuse capacities for each circuit correct?
3.
Are there any blown fuses?
If a fuse is to be replaced, be sure to use a new fuse
of the same capacity. Always determine why the fuse
blew first and completely eliminate the problem before
installing a new fuse.
BE -114
BODY ELECTRICAL SYSTEM
ICM (INTEGRATED CIRCUIT
MODULE) RELAY BOX
DESCRIPTION
EDD82CCE
The ICM is united with many kinds of relays and installed
below the body control module.
relay box (Assist compartment).
B
A
SCMBE6212D
1
5
6
7 8 9
2
3
10
11
4
1
2 3 4 5 6 7 8 9 10
13
11 12
14 15 16 17 18 19
[A]
[B]
SCMBE6213L
INSPECTION
E04C6F4C
REAR AIRCONDITION
Check for continuity between the terminals.
1.
There should be continuity between the No.2 and
No.3 terminals when power and ground are con-
nected to the No.1 and No.11 in the ICM-B.
2.
There should be no continuity between the No.2 and
No.3 terminals when power is disconnected.
ADJUST PEDAL
Check for continuity between the terminals.
1.
There should be no continuity between the No.12 and
No.13 terminals when power and ground are con-
nected to the No.12 and No.15 in the ICM-B.
2.
There should be continuity between the No.12 and
No.13 terminals when power is disconnected.
DEAD LOCK
Check for continuity between the terminals.
1.
There should be continuity between the No.9 and
No.10 terminals when power and ground are con-
nected to the No.18 and No.19 in the ICM-B.
2.
There should be no continuity between the No.11 and
No.10 terminals when power is disconnected.
DRL
Check for continuity between the terminals.
1.
There should be continuity between the No.8 and
No.9 terminals when power and ground are con-
nected to the No.4 and No.11 terminals in the ICM-A.
2.
There should be no continuity between the No.8 and
No.9 terminals when power is disconnected.
REAR FOG LAMP
Check for continuity between the terminals.
1.
There should be continuity between the No.6 and
No.7 terminals when power and ground are con-
nected to the No.3 and No.10 terminals in the ICM-A.
2.
There should be no continuity between the No.6 and
No.7 terminals when power is disconnected.
INDICATORS AND GAUGES
BE -115
INDICATORS AND GAUGES
COMPONENT LOCATION
E09EAE88
1*
3
2*
7*
8
9
10
6
5
4
1. Cluster assembly
2. Seat belt switch
3. Vehicle speed sensor
4. Engine coolant temperature sender
5. Oil pressure switch
6. Brake fluid level warning switch
7. Parking brake switch
8. Door switch
9. Fuel gauge sender
10. Tailgate switch
The parts with asterisk(*) :
This illustration shows the LHD type.
RHD type is symmetrical.
SCMBE6220L
BE -116
BODY ELECTRICAL SYSTEM
TROUBLESHOOTING
E78F78F1
Symptom
Possible cause
Remedy
Cluster fuse (10A) blown
Check for short and replace fuse
Speedometer faulty
Check speedometer
Vehicle speed sensor faulty
Check vehicle speed sensor
Speedometer does not operate
Wiring or ground faulty
Repair if necessary
Cluster fuse (10A) blown
Check for short and replace fuse
Tachometer faulty
Check tachometer
Tachometer does not operate
Wiring or ground faulty
Repair if necessary
Cluster fuse (10A) blown
Check for short and replace fuse
Fuel gauge faulty
Check gauge
Fuel sender faulty
Check fuel sender
Fuel gauge does not operate
Wiring or ground faulty
Repair if necessary
Cluster fuse (10A) blown
Check for short and replace fuse
Bulb burned out
Replace bulb
Fuel sender faulty
Check fuel sender
Low fuel warning lamp does
not light up
Wiring or ground faulty
Repair if necessary
Cluster fuse (10A) blown
Check for short and replace fuse
Water temperature gauge faulty
Check gauge
Water temperature sender faulty
Check sender
Water temperature gauge does
not operate
Wiring or ground faulty
Repair if necessary
Cluster fuse (10A) blown
Check for short and replace fuse
Bulb burned out
Replace bulb
Oil pressure switch faulty
Check switch
Oil pressure warning lamp does
not light up
Wiring or ground faulty
Repair if necessary
Cluster fuse (10A) blown
Check for short and replace fuse
Bulb burned out
Replace bulb
Brake fluid level warning switch faulty
Check switch
Parking brake switch faulty
Check switch
Parking brake warning lamp
does not light up
Wiring or ground faulty
Repair if necessary
Memory fuse (15A) blown
Check for short and replace fuse
Bulb burned out
Replace bulb
Door switch faulty
Check switch
Open door warning lamp and trunk
lid warning lamp do not light up
Wiring or ground faulty
Repair if necessary
Cluster fuse (10A) blown
Check for short and replace fuse
Bulb burned out
Replace bulb
Seat belt switch faulty
Check switch
Seat belt warning lamp does
not light up
Wiring or ground faulty
Repair if necessary
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст