Hyundai Santa Fe (2006 year). Manual — part 10
MECHANICAL POWER STEERING SYSTEM
ST -37
5.
Remove the return tube bracket bolts.
SCMST6531D
6.
Remove the front bumper and then loosen the cooler
tube bracket bolts.
[DIESEL]
SCMST6505L
[GASOLINE]
SCMST6512L
7.
Remove the power steering hose tubes.
INSTALLATION
E6EEDC80
1.
Installation is the reverse of removal.
NOTE
Be sure to connect between a tube and a hose as
shown in the illustration.
LPLG500J
CAUTION
The pressure tube does not twist and come in
contact with other components.
2.
Add the power steering oil.
3.
After installation, bleed the power steering system.
(Refer to air bleeding in ST group)
ST -38
STEERING SYSTEM
POWER STEERING OIL PUMP
COMPONENTS
E5FCB3BF
1. Bolt
2. Oil pump cover assembly
3. Gasket
4. Cam ring
5. Lock pin
6. Vane
7. Rotor
8. Side plate
9. O-ring(Inner)
10. O-ring(Outer)
11. Front housing
12. Suction pipe
13. O-ring
14. Bolt
15. Connector
16. Flow control valve
17. Flow control spring
18. Shaft
19. Pulley
20. Washer
21. Nut
21
20
19
18
14
55 ~ 65
(5.5~6.5, 40 ~ 47)
13
12
4
5
6
3
2
1
7
9
8
10
11
15
16
17
TORQUE : Nm (kgf.m, lb-ft)
LPLG500U
MECHANICAL POWER STEERING SYSTEM
ST -39
REMOVAL
EA4F3A9F
1.
Remove the intercooler assembly. (Diesel only, refer
to EM group)
SCMST6506L
2.
Remove the drive belt.
3.
Remove the alternator.
(Diesel only, refer to EE
group)
4.
Disconnect the oil pressure switch.
5.
Disconnect the pressure tube (A) and suction hose
(B) from the power steering pump assembly.
Tightening torque Nm (kgf-m, lb-ft):
55 ~ 65 (5.5 ~ 6.5, 40 ~ 47)
[DIESEL]
A
B
SCMST6538D
[GASOLINE]
A
B
SCMST6504L
6.
Loosen the power steering pump mounting bolt and
nut, and then remove the power steering pump as-
sembly from the pump bracket.
Tightening torque Nm (kgf-m, lb-ft):
17 ~ 26 (1.7 ~ 2.6, 12 ~ 19)
[DIESEL]
SCMST6532D
ST -40
STEERING SYSTEM
[GASOLINE]
SCMST6509L
NOTE
Be careful not to spill the fluid from the power steering
oil pump.
DISASSEMBLY
E32DF37D
1.
Remove two bolts from the oil pump body (A), and
then remove the suction pipe (B) and O-ring.
B
A
EPNG004A
2.
Loosen the four bolts and remove the oil pump cover
assembly (A) and the gasket.
A
EPNG005A
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст