Hyundai Tiburon (2003 year). Manual — part 184

TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Body (Interior and Exterior) > Interior > windshield glass > Components
and Components Location, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Body (Interior and Exterior) > Interior >
windshield glass > Components and Components Location

COMPONENTS

TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Body (Interior and Exterior) > Interior > windshield glass >
Repair procedures, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Body (Interior and Exterior) > Interior >
windshield glass > Repair procedures

REMOVAL

1. To remove the windshield, first remove the following parts:

(1) Front pillar trims

(2) Inside rear view mirror

(3) Wiper arms

(4) Weatherstrip and cowl top cover

(5) Windshield glass molding

2. Use the special tool (09861-31100) to cut through the sealant.

3. Make mating marks on the glass and body if the glass is to be reinstalled.

4. Take out the windshield glass with the special tool (09861-31400).

INSTALLATION

1. Using a cutter knife or the special tool (09861-31200), scrape the old sealant smoothly to a thickness of about

2 mm (0.08 in.) on the bonding surfacearound the entire windshield flange.

Be careful not to remove more adhesive than necessary, and also not to damage the paintwork on the
body surface with the knife. If the paintworkis damaged, repair the damaged area with touch-up paint.

2. Clean the body bonding surface with a sponge dampened in alcohol or wax and grease remover.

3. Install the spacer in the windshield aperture.

4. Center a new windshield glass in the opening. Mark the location by marking lines across the glass and body

with a grease pencil at the four points asshown.

5. Install the windshield glass molding without any gaps.

6. Glue the rubber dam to the inside surface of the windshield glass around the entire edge as shown, to contain

the sealant during installation.

Part

"A"

Remarks

Upper

13.5 mm

Glass molding sub

Side

13.5 mm

7. Apply a light coat of glass primer to the outside of the dam.

1. Never touch the surface applied primer with your hand.

If you do, the adhesive may not bond to the glass properly, causing a leak after the windshield glass
is installed.

2. Do not apply body primer to the glass.

3. Keep water, dust, and abrasive materials away from the surface applied primer.

8. Apply a primer to the lower glass as shown.