Hyundai Tiburon (2003 year). Manual — part 185
9. Apply a sealant around the edge of the glass.
Apply the adhesive within 5 minutes after applying the primer to the glass.
10. Apply a light coat of body primer to the original sealant remaining around the window opening flange. The
glass should be installed within 5 minutesafter you apply the primer.
11. Using suction cups or the special tool (09861-31400), lower the glass over the opening, align it with the
marks made in step 4 and set it down onthe sealant.
12. Scrape or wipe excess adhesive off with a putty knife or gauze. Fill all cavities around the windshield glass.
13. Perform a water-leak test for the windshield. Use a cold water spray, being careful not to direct a powerful
stream of water on the new adhesivematerial. Allow water to spill over the edges of the glass.
14. If there are leaks, dry the affected area, then apply sealant.
15. Install the removed parts.
1. Keep the windshield dry for the first hour after installation.
2. Let the car stand for at least four hours after windshield installation. If the car has to be used winthin
the first 8 hours, it must be driven slowly.
3. Take care not to slam the doors with all the windows rolled up.
4. Take care not to twist the vehicle excessively (such as when going in and out of driveways at an
angle or driving over rough, uneven roads).
TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Body (Interior and Exterior) > Interior > tailgate glass > Components
and Components Location, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Body (Interior and Exterior) > Interior >
tailgate glass > Components and Components Location
COMPONENTS
TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Body (Interior and Exterior) > Interior > tailgate glass > Repair
procedures, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Body (Interior and Exterior) > Interior > tailgate
glass > Repair procedures
REMOVAL
1. To remove the tailgate glass, first remove the following parts:
(1) Rear window defogger wire connector.
(2) Tailgate trims.
(3) Rear wiper and wiper motor.
2. Remove the tailgate glass in the same manner as the windshield glass.
INSTALLATION
1. Using a cutter knife or the special tool (09861-31200), scrape the old sealant smoothly to a thickness of about
2 mm (0.08 in.) on the bondingsurface around the entire tailgate glass.
Be careful not to remove more adhesive than necessary, and also not to damage the paintwork on the
body surface with the knife. If the paintwork is damaged, repair the damaged area with touch-uppaint.
2. Clean the body bonding surface with a sponge dampened in alcohol or wax and grease remover.
3. Center a new tailgate glass in the opening. Mark the location by marking lines across the glass and body with
a grease pencil at the four pointsas shown.
4. Install the tailgate glass molding without any gaps.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст