Hyundai Tiburon (2003 year). Manual — part 171

TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Restraint > Airbag Module > Side Airbag (SAB) Module >
Repair procedures, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Restraint > Airbag Module > Side Airbag
(SAB) Module > Repair procedures

REMOVAL

1. Disconnect the battery negative (-) terminal cable.

Wait at least 30 seconds.

2. Disconnect the side airbag harness 2p connector.

3. Remove the seat assembly and seat-back cover.

4. Remove the two mounting nuts and the side airbag.

1. Never attempt to disassemble or repair the airbag module.

2. Do not drop the airbag module or allow contact with water, grease or oil. Replace it if a dent, crack,

deformation or rust are detected.

3. The airbag module should be stored on a flat surface and placed so that the pad surface is facing

upward. Do not place anything on top of it.

4. Never attempt to measure the circuit resistance of the airbag module (squib) even if you are using the

specified tester. If the circuit resistance is measured with a tester, accidental airbag deployment will
result in serious personal injury.

TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Restraint > Airbag Module > Satellite Sensor > Repair
procedures, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Restraint > Airbag Module > Satellite Sensor >
Repair procedures

REMOVAL

1. Disconnect the negative battery cable and keep secure from battery.

Wait at least 30 seconds after disconnecting the battery cable before doing any further work.

2. Remove the front seat.

3. Remove the door scuff trim.

4. Remove the guarter trim. After removing seat belt lower anchor bolt.

5. Remove the floor carpet.

6. Disconnect the satellite sensor connector and remove the satellite sensor.

TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Restraint > Seat Belt Pretensioner > Seat Belt Retractor
Pretensioner (BPT) > Repair procedures, TIBURON(GK) > 2003 > G 2.7 V6 DOHC > Restraint > Seat Belt
Pretensioner > Seat Belt Retractor Pretensioner (BPT) > Repair procedures

REMOVAL

1. Disconnect the battery negative (-) terminal.

Wait at least 30 seconds.

2. Remove the door scuff trim.

3. Remove the quarter trim after removing seat belt lower anchor bolt.

4. Remove the upper anchor plate cover and upper anchor plate.

5. Remove the lower anchor plate and front seat belt.

1. Never attempt to disassemble or repair the BPT.

2. Do not drop the BPT or allow contact with water, grease, oil.

Replace it if a dent, crack, deformation or rust are detected.

3. Do not place anything on the BPT.

4. Do not expose the BPT to temperature over 93°C(20 0°F).

5. BPT functions one time only. Be sure to replace the BPT after it is deployed.

6. Be sure to wear gloves and safety goggles when handling the deployed BPT.